Patching Gap Around Light Fixture

The original light fixture had a rectangular base. The new one had a base that was barely larger than the electrical box. The electrician ended up with a slight gap on the left side of the box.

The wallpaper would most likely bridge that gap and look just fine. But since there was a slight difference in height between the wall and the base of the fixture, I wanted to close the gap to minimize chances of a visible pooch or bubble around the fixture.

I bought some drywall repair kits, and ended up using the one that had a thin aluminum mesh patch. I cut it to fit around the electrical box, using a few scraps to fill in gaps.

I then used drywall joint compound (“mud”) to smooth over the area. It took two of these skim coats, and a lot of time holding my heat gun to get everything to dry. Once sanded, it was nice and smooth.

A coat of Gardz penetrating sealer / primer, and the patched area was ready for wallpaper.

Elapsed time: Two hours.

This saved the homeowner having to hire “a guy” to do the repairs – and most likely, I would have had to “fine tune” whatever he did, anyway.

Tags: , , , , , , , , , ,

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s


%d bloggers like this: