Skooshing to Better a Kill Point


Re the dining room in yesterday’s post … a kill point is the point in a room where your last strip of wallpaper meets up with your first strip. This virtually always results in a pattern mis-match. So we try to put it in a corner behind a door, or some other spot where it won’t be too visible.

But this room (see yesterday’s blog post) did not have any hidden corners. If I had placed the kill point in one of the four corners, you would have had an eye-jarring, 5′ long pattern mis-match.

The areas over the doors and windows were only about 5″ tall, and way up high, so are not very noticeable. Especially the one over the entry way, because people’s eyes are focused on the far wall. So I decided to put the kill point there.

In the top photo, about 1/3 from the right, the pattern ended only about 1/2″ from matching perfectly. To be honest, this is not a bad look, and would have been acceptable as a finish point.

But I knew I could make it look better.

I took the piece to the left and cut it apart, following the curvy design. I made two such cuts, turning it into three separate pieces.

Then I skooshed the pieces to the left, overlapping that excess 1/2″ (divided between the three strips).

In the finished photo, you can’t tell that the original pattern doesn’t match perfectly, nor that some of the motifs are 1/4″ narrower than they were originally printed.

From the floor, this kill point is undetectable.

Tags: , , , , ,

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s


%d bloggers like this: