Doing the Opposite Today – Removing Wallpaper


The large medallion on soft lavender on all walls of this large bedroom worked well for this gal for many years – but now that she’s an older teen, it was time for an update.

So instead of putting wallpaper up, today I took it down.

Most people think that stripping wallpaper is difficult. But if the walls were prepped properly, and if the paper was hung properly, and if the proper removal steps are followed, it should all go well, with minimal damage to the walls. See my link at right, on how to strip wallpaper.

The most important thing is to separate the top, inked layer of paper from the backing / substrate layer. I find that wetting this top layer with a sponge and plain water helps strengthen the fibers, so the top layer can be pulled off in larger strips.

In the second and third photos, you see how the purple layer has been stripped off, leaving the white backing attached to the wall. This top layer has to be removed, because it has an acrylic (or vinyl) coating, and will not allow water to pass through it.

The next step is to soak the backing with plain water and a sponge (see photo). No chemicals, no additives – just plain warm water. You will have to reapply water several times. The idea is to let water soak through this backing layer, to reactivate the paste underneath. Once that paste is good and wet, it should release from the wall. Sometimes you have to gently scrape the backing from the wall. But in my case today, once that paste was reactivated, the substrate layer came away from the wall in full, intact sheets. Easy peasy!

One photo shows my “dull” 3″ stiff putty knife. I call it “dull,” because it’s old and beaten up. But it’s really rather sharp. I use it to carefully get between the inked top layer of wallpaper and the bottom substrate layer. And then I use it to gently scrape wallpaper from the wall.

In my case today, the previous installer had done a superb job of hanging the wallpaper. He applied a primer before hanging the paper. That primer helped make this whole removal job go well, and it protected the walls from damage.

The family will need to apply a stain blocker to prevent any residual paste from causing the new paint from crackling or flaking off. Once that’s dry, the walls can be textured and / or painted. The room’s resident told me that she is planning to go all white.

This home is in the West University area of Houston.

Tags: , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s


%d bloggers like this: