Kitchen With Burst Pipe Water Damage Fixed and Finished

This kitchen in the Spring area of north Houston suffered severe water damage from burst pipes during the hard freeze in February 2021. Nearly a year later, they are almost finished with repairs, including new drywall on bottom of walls, new cabinets, new plumbing, cabinets, electrical, and more. Here you see the contractor’s repair work on top of some of the original wallpaper, which dates to the early 1980’s! It was a good brand, and the installer did a great job. For various reasons, I opted to leave this wallpaper in place, and so skimmed over uneven areas and then primed on top of it with Roman Pro 977 Ultra Prime.
The homeowner’s new choice is very similar to the previous paper, but with a more springy feel and a lot of upward movement. The area below the chair rail will receive another coat of paint to better define the correct yellow color. Or, the homeowner may switch to a green pulled from the leaves in the pattern.
This wall with the fir-down / soffit was a real bugger, for various reasons, and took me about four hours.
Looks so sharp against the white paint and tile!
The wallpaper was printed on a white substrate, so I ran black chalk along the edges of each strip, to try to prevent white from showing at the seams. Still, some of the strips shrank just a half a tad, and that did allow some white to show. This wallpaper is a non-woven material, which has a high polyester content, and is not supposed to stretch or shrink, so this is disappointing. Pasting the wall and dry-hanging the material would have probably helped. But the material was extremely thick and stiff, and plus the room had way too many turns and bends and angles, so pasting the paper made the most sense. These gaps are very minor, and only visible when viewed from straight on; from an angle you can’t even see them. On some papers, I can pull some tricks out of my bag and camouflage them. But with this non-woven material, don’t even try anything with paint, marker, chalk or anything else – it will surely stain the material.
The walls are smooth. The slight texture you see is the non-woven material. When an edge is torn, you can actually see the polyester fibers – a lot like fiberglass. This material is very strong, and is designed to strip off the wall easily and in one piece when it’s time to redecorate.
Manufacturer is Mind The Gap out of Transylvania (!), and the design is called Aquafleur, in the Anthracite color. The material comes as a 3-panel set, which they call one “roll.” The overall width of the A, B, and C panels side-by-side is about 5′, and the height is just under 10′. The height of the wall was less than 5,’ and the strips were nearly 10′ long, so at least 5′ was lost of each strip. Because the pattern was a mural type, rather than a typical repeating wallpaper design, even more paper was lost in working around the configurations of the room – for instance, a full 10′ strip would be needed to paper just one 9″ high strip above the door. So there was an incredible amount of waste – and this is a higher-priced boutique brand. But the lady of the house really loves it, and so she went with her heart.

Tags: , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s


%d bloggers like this: