I usually do my own prep, but this time the homeowner had her contractor strip the existing wallpaper. This photo is to show you the toilet paper holder close up. You’ll have to imagine it without the wallpaper, as it was when I arrived to start this project. Fixtures like this, including towel bars and rings and many light fixtures , can be removed by loosening the recessed set screws , which are usually on the bottom of the fixture. They will take either a very small flat-head screwdriver , or a small allen wrench . These sit very close to the wall, so you have to be careful not to let your tools scratch or mar the wall as you work. Here’s a close-up of the underside of the fixture, showing the recessed set screw. In this case, an allen wrench was needed. Most fixtures take the same size wrench. Here I’m using my American set. But you occasionally will need a metric set.Once I got the holder off, I discovered that the contractor had not bothered to remove the toilet paper holder, but had cut around it. In doing this, he also left some of the original wallpaper. Also, by cutting around the fixture, he scored into the wall, which is not good because it breaks the surface and creates a potentially unstable surface that can come apart over time. In addition, it took them a whole lot of time to work around this fixture to remove the old wallpaper and then repair and smooth the wall. The whole business makes little sense, because it’s ultimately easier and faster to simply remove the thing. No damage to the wall, and then wallpaper can go behind the fixture leaving no cut edges around it. Here I’ve hung the wallpaper and marked the holes for the screws.Mounting bracket back in place.Toilet paper holder reattached.
This entry was posted on May 14, 2022 at 10:02 pm and is filed under Uncategorized. You can follow any responses to this entry through the RSS 2.0 feed.
You can leave a response, or trackback from your own site.
The Wallpaper Lady's Blog 
Leave a Reply