Using One Strip to Cover Two Areas Saves Wallpaper

This wallpaper is 20″ wide . My next strip to the left needs to be 20″ wide above the window – but only 1.5″ wide down the side of the window. I hate to use a whole 6′ long strip for this area. Because, as you can see, most of the strip will be where the window is, and will be cut off and thrown away.

But here’s a plan. The same thing is happening on the right side of the wall, on the window to the right. About 10″ of the wallpaper has extended over the window, leaving about 10″ of the lower portion to be cut off and thrown into the trash.
NNo! Since I need a 1.5″ width of a right edge to finish my area on the left side of the wall (see previous photo), I can use this discarded lower 10″ of wallpaper to cover that 1.5″ to the left.

Planning ahead and measuring carefully, I removed the lower section of wallpaper that would have been hanging over the window / shutters . I left plenty of overlap to allow for trimming along the top and along side the window molding. Added bonus – because I’m now not wrestling a 20″ wide strip of paper next to this window and shutters, it keeps a lot of paste from slopping onto the window molding and shutters .
zin this photo, you see the 10″ wide strip I’ve removed. And also the 1.5″ wide strip from the left right edge, that will be put against the strip to the left.

Here’s my 1.5″ wide strip.

And here’s where I’m going to put it. Note that I cut a short strip to fit over the window . It’s 20″ wide – the width of the roll of wallpaper . I cut it long enough to come down the side of the window to where there’s a design element – in this case, a horizontal branch – to disguise the juncture of these two pieces of wallpaper .

About to go into place .

Positioned. Note the overlap of the branch, trimmed along the lines of the motif. This makes the overlap way less noticeable than a straight horizontal patch, or even a splice.
Note: I don’t like to splice / double cut in situations like these – cuts into the wall surface below and can cause the paper to come away from the wall. I don’t mind overlaps in these situations. They’re up high where no one can see, and also much stronger and more stable than a butted edge .

Teimming off excess along the window molding / trim .

Doone!

The tree and leaf pattern is called Twining and is by Graham and Brown . Like most of their materials, it’s a non-woven material and can be installed by pasting the wall – although I usually paste the paper . It is designed to strip off the wall easily and in one piece when it’s time to redecorate . The seams are invisible .

Tags: black wallpaper, branch, butted, design, double cut, easily, edge, element, graham and brown, horizontal, invisible, leaf, measuring, molding, motif, non-woven, noticeable, overlap, paste, paste the paper, pasting the wall, patch, redecorate, roll, seams, shutters, splice, strip, strip off the wall, surface, tree, trim, trimming, twining, wallpaper, window