Posts Tagged ‘angles’

Slip Paper Behind Molding

January 26, 2023
It’s so nice when the trim carpenter leaves a little space between the molding and the wall. Rather than spending 20 minutes trimming around these multiple angles and protrusions, I will be able to merely slip the wallpaper behind the corbel (decorative molding).
Added bonuses are that there will be no worries about edges of wallpaper curling up or away from the wall .
I also believe this teeny gap is beneficial to give some ease, in the very common event of the walls shifting and moldings stretching or shrinking. All due to humidity and temperature and rain fall … and settlement of the home’s foundation, and more.

Picasso Slept Here – Crazy Pattern in a Complicated Powder Room

November 11, 2022
This is a fairly large powder room with a sloped ceiling, as it is situated under the stairs. You can see a bit of the ceiling at the top of the photo. The room also had this odd recessed niche with “columns” on either side, and a door leading to a closet.
In addition, there were tons of the rounded / bull-nosed edges that have been common in new homes in the last 10 years or so. These are tricky to wrap wallpaper around, and equally difficult to trim wallpaper to the edge.
Here is the niche area done, with wallpaper wrapped around the columns, and cut neatly along the horizontal bull nosed edge above the entry.
Wrapping the wallpaper around this edge and onto the ceiling of the niche would have made the area way too busy and claustrophobic. Because these edges are never perfectly straight and level, it’s also quite likely that the wallpaper will go crooked, and you’ll end up with gaps or overlaps at the seams.
A better option is to paint that ceiling area. I suggested the murky green color that’s in the leaves on the wallpaper pattern.
Here’s the east wall of the room. The vanity and sink are at the bottom right.
Here it is finished. In this case, the fir-down underside was only about a foot deep, so less chance of the wallpaper going crooked, so I did wrap it around the rounded edge and underneath. Still, one of the wallpaper strips did twist askew, and there was a small gap at one seam. With this pattern, no biggie – I just cut out a leaf and pasted it over the gap.
I told you the room had crazy angles!
Note that in papering angled areas like this, you can match the pattern in some places, but there will be mis-matches in others, such as where the sloped ceiling meets the fir-down. This wild pattern is perfect for disguising any mis-matches!
Rolling the paper out on the floor, to get an idea of the pattern’s layout .
Closer look at the lemons and leaves . And angles .
It looks like a Picasso painting, don’t you think? The homeowner wanted something wild and fun , to set off the white minimalism in the rest of the home .
The pattern is called Citrus and is by A Street Prints . It’s a nice non-woven material , doesn’t expand , and can be hung by the paste the wall method , although I opted to paste the paper , as I usually do.
Non-wovens are designed to strip off the wall easily and in one piece, with no / minimal damage to the wall when you redecorate . They’re usually a pleasure to install . They’re more stain resistant and more able to withstand humidity than many traditional wallpapers .
The home of this busy young family is in the West University area of Houston .

Using Heat To Bend Vinyl

September 3, 2022
I will be wrapping a stiff , thick , embossed textured vinyl wallpaper around the inside of this window return . This 90* angle is called an outside corner . This is tricky enough.
But the real feat will be wrapping the material around that bend , and getting it to adhere to that little lip on the bottom next to the wainscoting – which is only about 1/4″ deep . That doesn’t give much for the paper to grab hold of, especially since it is stiff and will want to retain it’s flat position .
Heat gun to the rescue! Heat will cause the vinyl to soften and allow it to bend . This is my test piece. I’m experimenting with how much heat is needed and the delicate balance between bending and melting or burning .
Also how much time is required for the vinyl to cool and how well it will retain its new shape , and how firmly it will adhere to that little narrow 1/4″ lip .
Because I can’t safely put my hands in front of the heat gun, and my plastic smoother tool would not hold up, I use this ” Euni Plate ” of stainless steel , which was invented and manufactured and sold by a colleague of mine in the Wallcovering Installers Association WIA .
Here’s another view. The plate has angles and rolled edges for various uses. The damp cloth is to quickly cool the vinyl, in hopes to keep it in the bent shape .
Another trick is to use a straightedge and razor blade to gently and lightly score the vinyl along the outside of the corner fold , to break the surface a little and allow it to bend . You’ve got to be careful, because cut too deeply and you’ll end up with a sliced edge that’s unattractive and also may delaminate ( come apart ).
Finished – with nice tightly wrapped edges that are staying in place .
wallcovering installer houston installation

Dogs Have Their Own Room – Complete With Wallpaper!

May 24, 2022
Here’s an unusual but clever use of under-the-stairs space. It’s a series of three rooms, pretty much intended for storage / closet area. The height of the walls gets shorter / lower as you move further under the stairs.
The homeowners decided to use the outer / taller room as a lounge for their dogs.
As you can see, plain old tile floors and wall paint don’t quite cut it … These pooches get their own room, complete with wallpaper !
Looking from taller, outer room into middle and then into the inner, smallest room.
Only the outer, taller room gets wallpaper.
Lots of angles, under the stairs.
2 1/2″ wide space between door moldings.
I had fun choosing which part of the design to slip into this narrow area, to ensure we’d see the most dogs and with the least parts cut off.
Design is called Doggies and is by Milton and King . They make really nice wallpaper , although some patterns can be tricky to measure for, so consult your installer before ordering.
This is a non-woven product, and can be hung via the paste-the-wall method of by pasting the paper.

Burnished Copper Colors in Home Bar Area

May 6, 2021

tThe homeowner loved the coppery-hued colors in this “Carousel Stripe” pattern by Cole & Son. The colors mesh beautifully with the wood tones, and also the brass faucet, in this home bar area.

What’s interesting is that I think the colors (especially the red) are more intense now, than in the samples she got from the vendor. In fact, one complaint of hers was that the vendor sent just one small snip of the paper, and didn’t show the full color spectrum of all 10 stripes that make up the pattern.

No matter. The finished effect really sets off the bar backsplash, and will be a fabulous backdrop once the bottles and glasses are back in place.

This wallpaper is a non-woven material, which is made of synthetic fibers rather than wood or cotton pulp. Instead of the paste-the-wall installation method, I chose to paste-the-paper. This made the material more flexible and manageable, which helped a lot, because when it was dry, it really wanted to crease and flake.

TFor instance, the racks sitting on the counter in the first photo could not be removed. Manipulating, fitting and trimming the wallpaper around the sharp bends and angles without marring the wallpaper was very difficult.

The non-woven, synthetic-origin material (think fiberglass) was also really hard to cut. Even with a brand-new razor blade, I had trouble getting perfect cuts around moldings, and also in a whole lot of other simpler areas.

These two rooms were hard enough, with minimal angles and corners and intricate moldings. If this had been a bathroom, or another room with a lot of turns and fancy cuts, it would have been really difficult to prevent creases and other damage to the wallpaper.

As it was, I spent about nine hours hanging these four single rolls of paper.

This is a wonderfully restored 1939 home in the Rice University area of central Houston.

Crazy Corners & Angles

February 9, 2021

No wonder it took me two days to hang this powder room!

Soft Geometric in Bedroom Niche

June 23, 2019


This is an alcove leading into a master bedroom in a new townhome in the Houston Heights. This niche is recessed between bookshelves on either side, and above.

The geometric pattern of blocks and angles with gold metallic accents adds a modern touch, and the soft color promotes the feel of calm relaxation. Brass sconces will be mounted over the electrical boxes, and the homeowner has a settee that will be placed in the center.

This was a non-woven wallpaper, and I hung it using the paste-the-wall method.