aaHere’s what this flowing viny wallpaper pattern looks like in this dining room in the Garden Oaks / Oak Forest neighborhood of Houston . The bottom 1/3 of the wall is block paneling / wainscoting , so the wallpaper on just the area above is not overwhelming . A kill point is the place in a room where your last strip of wallpaper meets up with the first strip you hung . this virtually always results in a pattern mis-match . So we try to hide that in an inconspicuous place, such as in a corner behind a door . In this room, all of the corners are very visible . A mismatched corner of 7′ high would be very noticeable . So in this room, I was able to cleverly disguise the mis-match in a much shorter area, over a door . This is only 6″ high . Here my first strip is on the left, and my last strip is on the right, with two short strips needed to bridge that gap . Here the strip on the right has been put into place. Here’s the piece that will butt up against the strip on the left. Eeek! It’s 1/2″ too narrow to cover the gap. Also, as you can see, there is an obvious pattern mis-match at that seam on the right. look at this tree branch . I’m going to use that to my advantage.Here I’ve taken another piece and have matched the pattern on the right side. Note that it’s not matching on th left. Here I am, back to that strip we saw a few photos ago, that will match with the strip on the left. Remember tha tree branch I pointed out? Here I’ve trimmed the wallpaper vertically along that tree branch . Here I’m putting it into place, butting it up against the strip on the left, and overlapping the strip on the right. But that’s going to leave a vertical ridge under this strip, where the strip underneath it ends on the left. But you won’t notice that overlap if it runs under a design motif . Here I’m using a pencil to trace the outline of that tree branch, bringing it in so that the tree branch will overlap just 1/8″ – 1/4″ over the strip on the right. Note that since the surface of this paper is vinyl , and wallpaper paste doesn’t always adhere well to slick plastic , I’ve used a special border paste or vinyl over vinyl or seam repair adhesive just on this small 1/8″ overlapped area . Strip on the right trimmed to conform to the curves of the tree branch. Tree branch piece being put into place. Tree branch strip trimmed and finished. SDone and viewed from below. OK, so the pattern doesn’t match 100% perfectly the way the designer intended. Some of the motifs are closer together than they “should” be. From here, who the heck is going to notice?! This looks pretty darned good – and it looks way better than having a 7′ long mis-match in a very visible corner . The pattern is called Twining and is by Graham & Brown . It has a very light texture , and also a slight metallic sheen on the branches . It’s a non-woven / paste the wall material , and will strip off the wall easily and in one piece when it’s time to redecorate . I like their papers a lot . You can purchase G&B from Dorota at the Sherwin-Williams in the Rice Village . Call first, as hours vary. (713) 529-6515 . Here’s another cool thing … Go back to that first photo. Since I started hanging paper by centering the pattern between the two windows on the wall to the right (not visible in the photo), by the time I worked my way around to the wall between the windows you see in front of you, the pattern was not going to be centered in between the windows. I thought it would look better if it was balanced symmetrically. So I positioned the dominant part of the tree branches in between the windows. And then I used the same overlap-and-disguise trick over the window on the right.
Before. Heavily textured wall has been skim-floated with smoothing / joint compound and then sanded smooth , and then primed with Roman Pro 977 Ultra Prime wallpaper primer . I’ve run a narrow line of dark green craft paint along the top of the chair rail / wainscoting , due to uneven edges . More on that in a soon-future post. Sink wall is done. Pattern is centered nicely on the faucet and in between the electrical boxes for the new sconces – They haven’t arrived yet and will be installed in a few weeks . The homeowner’s carpenter created this beautiful wainscoting out of 3D block paneling , and then painted it a rich dark hunter’s green . Right now there’s some sanding dust collected on it, plus bad lighting . In person, it’s gorgeous . The same company did a fantastic paneled wall / fireplace surround in the family room (not pictured) . Back to wallpaper … This shot is pretty color-accurate. I love the way the dark wallpaper coordinates with the green paneling . The pink and orange flowers , as well as the row of purple foliage , really stand out against all the dark . Close-up looks like an artist’s painting . Besides centering the pattern on the sink wall, the dimensions worked out so that I was able to balance the chameleons between the ceiling and chair rail , one just below the ceiling and the one here just above the chair rail. So no critter got cut in half . This product comes as a 2-strip (roll) set , with an “A” strip and a “B” strip in each box. Together, the two strips equal just a hair under 6′ wide , and a little over 9′ high . Here I’m rolling out the two strips so I can gauge the pattern , measure width and height , and plot the layout on the wall. Sobering fact: Each 2-strip set (one “roll”) cost about $500. This room used four of those sets. I always try to keep that in mind when working with people’s purchased wallpaper . OK, this damned Word Press blog account has AGAIN (2nd time in two nights!) deleted paragraphs that I spent a lot of time typing. I can’t recreate all the info I put into that lost post, but below I will try to include some of the important points. First and foremost – since the switch to the New Editor back about 2015, I pretty much HATE WORDPRESS . Anyway, here the company is providing a mock-up of what the “A” and “B” strips look like. The mock-up above shows the two panels next to each other. Since this is essentially a mural and the pattern doesn’t repeat vertically as more typical wallpapers do, you can plan on getting only one strip out of each panel. These walls are 6′ high , and the panels are 9′ high. So you’re losing 3′ with every strip. Further, the area over the door needed one panel that’s 2′ high. But an entire 9′ panel was needed for this, to get the 2′ high strip. So 7′ are going into the trash. Add to that, since this product comes as a 2-panel set , the homeowner had to buy a 2-panel set (at $500), even though only part of one panel would be used. This means that 1 + 2/3 9′ long panels were purchased but not used. Also, because this comes in panels instead of traditional rolled goods, there are no “extra” strips. This means that I can’t make any mistakes. Nothing like a little pressure while trying to install wallpaper ! No fears … this pattern and material went up nicely, and we had just enough paper to git ‘er done. Manufacturer is Breeze and the pattern is called Fantasy Tree . It was purchased from one of the show rooms in one of the Design / Decorative Centers in central Houston. It’s printed on the user-friendly / DIY – friendly non-woven material , which can be hung by pasting the paper (which I prefer) or the paste-the-wall method . It’s designed to strip off the wall easily and in one piece with no damage to the wall when it’s time to redecorate . Definitely better than peel & stick (click my link on the right to read more about P&S ). The home is in the Oak Forest / Garden Oaks / Heights neighborhood of Houston .
What a cute pattern! Suited for a boy or girl, and will “grow” with the child for several years.Before. The parents had this block paneling wainscoting added before the wallpaper went up. It keeps the wallpaper pattern from being overwhelming, and the green color really sets off the colors in the wallpaper. Trees , flowers , forest animals , deer , leopards , peacocks , birds . Made by Rifle Paper by York , one of my favorite brands. Rifle Paper is a non-woven material , DIY – friendly , and designed to strip off the wall easily when it’s time to redecorate .
The bottom of these walls are covered in beautiful block paneling. Originally, the top of this bedroom belonging to a little girl in the Woodland Heights neighborhood of Houston was painted tan. Tan’s a nice, safe color – but it’s bland and boring and is totally not up to the energy and zeal for life of a toddler.
Interior designer Rachel Goetz found this cool watercolor-like design from Anthropologie. It’s colorful and fun, and, if you look closely, there are hidden grasshoppers, butterflies, and ants!
The wallpaper is in the Sure Strip line made by York, one of my favorite papers – but this Ant pattern (also called “Watercolor Peony”) is only available through Anthropologie. It’s pre-pasted, and very thin, and no worries about curling seams. Sure Strip is designed to come off the wall easily later, when you’re ready to redecorate.
The Wallpaper Lady's Blog 