Skim-Floating to Smooth a Textured Wall

Wallpaper is to go on the top 2/3 of the walls in this large dining room. But the walls are textured, and that texture will show through the new paper. Which looks pretty bad , IMO , especially since most the design is plain white background. So here I am applying a skim-coat by skim-coating / skim-floating the wall to smooth over the texture.

Close up. A lot of people use a wide broad knife or drywall taping tool . But I prefer the control I have using this trowel . There will be ridges and valleys and imperfections . But tomorrow, when the smoothing compound is dry , I will sand everything smooth . I have to say, I’m pretty darned good at smoothing walls . 🙂

I like to use the Plus 3 Joint Compound by the Sheetrock brand. It’s much easier to sand than the standard joint compound . Do NOT use the ” quick set ” version – coatings such as primer , paint , or wallpaper don’t like to adhere to this stuff . It’s made for small patches , not covering entire walls. BTW, for short, we simply call this ” mud .”

Once the walls have been sanded smooth , all the dust vacuumed up, and residual dust wiped off the walls with a damp sponge , then I will apply my favorite primer, Roman Pro 977 Ultra Prime , made specifically for use under wallpaper .

Smoothing Over A Mess

This kind homeowner had the sink / vanity in this powder room removed. This makes it a LOT easier and faster for me to to get the wallpaper up, and with less stress on the paper and fewer relief cuts .

Removing a sink that’s attached to the wall often damages the surface. Here you can see how the workman used spackle compound to cover the torn drywall and other damage.

s

Close-up. This isn’t a very smooth surface, and the wallpaper will have a hard time grabbing ahold and adhering. It’s also way too porous and crumbly to support wallpaper.
In the top photo, you see where I have applied smoothing compound on the upper portion of the wall. I’m working my way down.
Once it’s dry, I will sand and prime it, and it will be nice and smooth.

Here’s a shot of the fresh smoothing compound, before sanding.

Some people use a drywall taping knife or a broad knife to apply the plaster-like substance. I prefer the trowel you see in the photo, because it gives me more control and precision.
The 2″ flexible putty knife is for getting into smaller areas. The 3″ stiff ” Hyde ” putty knife is for knocking off high points or bumps on the wall before applying the smoothing compound.
This process is called skim-floating or skim-coating .

I like to use the Plus 3 lightweight joint compound made by Sheetrock . We just refer to it as mud . Find it in the drywall aisle.
The Plus 3 spreads on easily enough, sands easily , and the dust falls to the floor where it can be vacuumed up easily – as opposed to getting air-borne and drifting all over the place.
This box, which is approximately one cubic foot , weights 32 pounds . Ugh. Try carrying that across a parking lot and then up to the third floor of a townhome!

I like to transfer the material to a 5-gallon bucket. This is what it looks like in the bottom of the bucket.
Easy to scoop out. When I’m finished, I use a wet hand to smooth down the surface, wipe residue off the sides of the bucket, then place a thick sheet of plastic over the surface to keep air from drying it out. Then, of course, I put the lid onto the bucket.