Posts Tagged ‘bubbled’

Wall Sealing Whoops

September 26, 2018


Today I prepped a room where the drywall had been badly torn when the old wallpaper was stripped off. This happened because the original installer hung the wallpaper directly on the drywall, with no coat of paint or primer to protect the drywall.

Before I could smooth the wall surface, I had to seal the torn drywall, because moisture on the torn areas would cause the brown paper to bubble. I rolled on a heavy coat of Gardz, a water-thin, penetrating product that is designed to soak into the porous material, bind everything together, and dry hard. It is supposed to dry inpenetrable by water.

Once it was dry, I skimmed over it with joint compound (which will be sanded smooth later).

As you can see, the Gardz failed to do as claimed, and it allowed moisture from my smoothing compound to seep through it and enter the torn paper of the drywall, which then expanded and bubbled. I’ve got a big mess on my hands!

Tomorrow, when everything is dry, I will sand smooth. Usually bubbles like this dry out and then sand flat. But the large loose areas have me a little worried. They may still be loose and bubbled, and they may swell again when the wall is given its final coat of Gardz.

I may end up having to cut out some loose areas, refloat, and reprime.

Not good, because this could add a full day to this job, and because there could potentially still be unstable areas under the surface. Never good to have an unsecure surface under your wallpaper.

Narrow Strip Coming Out of a Corner

August 28, 2018


See that narrow 3/8″ wide strip of wallpaper sitting on my table? That is to be my first piece coming out of this corner.

When you hang wallpaper around an inside corner, you don’t wrap it around the turn, but, rather, split the piece vertically so it wraps 1/16″ around the corner. Then the strip that you cut off is hung on the next wall, butted up into the corner. This avoids twists and wrinkles and bubbled areas caused by walls and corners that are not perfectly straight or plumb.

But when the piece that is to be the first strip on the new wall is this narrow, it presents problems, because it’s very likely to not hang straight, and you can’t hang the next strip of wallpaper against a crooked edge because you will get gaps and overlaps.

Adding to the dilemma is that this narrow strip had already been pasted. I had finished for the day, and intended to hang the window wall to the left the next day. The strip was already pasted, but I couldn’t hang it because of the aforementioned issues, plus, you are supposed to hang a whole wall at a time, because all of the strips have to “meld” together – you can’t hang a wet piece against a dry piece.

My solution was to wash the paste off this narrow strip, and hang it up to dry overnight. I just had to hope that the water would not cause it to expand too much, or warp, or other.

The next day, I pasted this narrow 3/8″ wide strip, along with the strip that would be placed next to it. Then I hung them together, as if they were all one piece of wallpaper. That way, I could work them into the corner snugly, and keep the seam between them nice and tight.

When coming out of corners, it’s common for the wallpaper to go off-plumb, because the corner might be out of wack. So you can (barely) see the red line of my laser level on the left edge of the strip of wallpaper, ensuring that the new strip falls plumb.