Posts Tagged ‘butted up’

Narrow Strip Coming Out of a Corner

August 28, 2018


See that narrow 3/8″ wide strip of wallpaper sitting on my table? That is to be my first piece coming out of this corner.

When you hang wallpaper around an inside corner, you don’t wrap it around the turn, but, rather, split the piece vertically so it wraps 1/16″ around the corner. Then the strip that you cut off is hung on the next wall, butted up into the corner. This avoids twists and wrinkles and bubbled areas caused by walls and corners that are not perfectly straight or plumb.

But when the piece that is to be the first strip on the new wall is this narrow, it presents problems, because it’s very likely to not hang straight, and you can’t hang the next strip of wallpaper against a crooked edge because you will get gaps and overlaps.

Adding to the dilemma is that this narrow strip had already been pasted. I had finished for the day, and intended to hang the window wall to the left the next day. The strip was already pasted, but I couldn’t hang it because of the aforementioned issues, plus, you are supposed to hang a whole wall at a time, because all of the strips have to “meld” together – you can’t hang a wet piece against a dry piece.

My solution was to wash the paste off this narrow strip, and hang it up to dry overnight. I just had to hope that the water would not cause it to expand too much, or warp, or other.

The next day, I pasted this narrow 3/8″ wide strip, along with the strip that would be placed next to it. Then I hung them together, as if they were all one piece of wallpaper. That way, I could work them into the corner snugly, and keep the seam between them nice and tight.

When coming out of corners, it’s common for the wallpaper to go off-plumb, because the corner might be out of wack. So you can (barely) see the red line of my laser level on the left edge of the strip of wallpaper, ensuring that the new strip falls plumb.

Workin’ On Ridding A Wrinkle

January 30, 2018


Even though this is a brand-new house, erected by a skilled custom builder, all of the walls, floor, and ceiling were off-plumb / unlevel. That’s not such a big deal when working with a wild abstract pattern or a typical floral. But when a geometric wallpaper pattern like this is applied to out-of-kilter walls, the resulting pattern match is going to be very visible.

In the top photo, the wall to the left is bowed. Trying to get a straight strip of wallpaper to fit into the crooked corner resulted in two very large (24″ high) wrinkles near the floor. That makes it difficult for my next strip of wallpaper to butt into the corner tightly, and to match the pattern, and still maintain its straight edge on the right side. This edge has to stay straight, because subsequent strips of wallpaper will be butted up against it.

My solution was to make some vertical “relief cuts,” following along the design motifs (top photo), from the baseboard up to the point where the wallpaper begins to torque out of shape. Because the wrinkles were so big, I had to make two vertical cuts, instead of just one, to ease the resulting pattern mis-match out over several inches, so it would be less noticeable.

When smoothed back into place, you could not see any pattern mismatch at all. (second photo)