Think It’s Time For A New Brush?

Here’s the brush I’ve been using for cutting in my wallpaper primer around corners and moldings. It’s called a ” Short Cut .”
I love the little stubby handle. But not the stubby bristles! Nor the residue accumulated near the base and within the bristles, which makes the brush stiff.
Even though I clean it thoroughly after each use, residue builds up. Me needs me a new one!

Here’s the same brush, but this is the one I use for cutting in paste on paste-the-wall wallpapers.
Paste washes out better than primer, so this brush looks nearly new, even after more than a year of use.
I’d like another one of these, please!

My Short Cuts were from Home Depot. I love Home Depot – but Sherwin-Williams is more convenient. Plus, this week they’re having a 35% off sale for contractors. Can’t beat that!
My local S-W didn’t have the style I’m so fond of, so I went with this version by the same manufacturer ( Purdy ). It’s similar but has a slightly longer handle.
I thought I wasn’t going to like it much, but I used it today and turns out I barely noticed a difference!

Smoothing a Textured Wall, Continued

Continuing from yesterday’s post … The smoothing compound has dried and I’m ready to sand it smooth. This photo gives an idea of what needs to be sanded down. Some areas, such as around electrical outlets, are more irregular and have more raised areas to be sanded down.

Before I get to the sanding, a 3″ stiff putty knife comes in handy for scraping down high areas.

For decades, contractors wrapped sandpaper around a wooden block and used that to sand walls. Then, about 25 years ago, some genius invented these sanding sponges. They’re soft, flexible, easy-to-hold blocks covered with sanding fibers of various grits. They have angles that aid getting into various corners. I find that the edges can be a bit “pointy” and can gouge into the surface, so I often use a scissors to cut off the corners, as you see in all but the one on the far left.

Held against the actual wall.

Don’t forget a dust mask, to prevent inhaling the fine particles. And, yes, this is an N-95 … The same mask that protects us from ingesting the COVID 19 virus also protects the lungs of us home improvement contractors.

Manufacturers have done a good job of creating joint compound whose dust settles to the floor, rather than going air-borne and sifting all around the room. Still, it’s best to take measures to keep dust out of the rest of the home. Here I’ve hung a sheet of painter’s plastic across the wall, to contain sanding dust.

Once I’m done sanding, I’ll use my Shop Vac to clean up the mess, removing dust from both the floor and the walls.

It’s crucial that all dust be removed from the wall. If not, it’s like flouring a cake pan – the wallpaper (or paint) will kinda stick – but not really stick. Vacuuming the wall will not remove all dust. The only way to remove all residual dust is to wipe it off the wall with a damp sponge.

Look at how much dust has accumulated on the sponge after only a few swipes.

The sponge needs to be rinsed clean frequently. Once I’m done, I’ll dump this bucket of dusty water down the toilet (not the sink).
Swipes from the damp sponge will leave wet marks on the wall. These need to dry before moving to the priming step, so as not to trap moisture within the wall surface.

Here I’m rolling on my favorite wallpaper primer, Roman Pro 977 Ultra Prime. I have my paint store guys add just a bit of blue tint, to help me see where I’ve rolled it on. The short angled brush is for cutting the paint in around corners and edges.
I’ve tacked strips of dropcloth along the top of the baseboards, to prevent splatters.

Finished wall, nice and smooth, primed, and ready for wallpaper.