Posts Tagged ‘deliminate’

Overlapping At The Seams

June 30, 2021

Re my previous post … the strips on this 6-panel mural are intended to be overlapped, by about a full inch.

There are advantages to this. Since wallpaper shrinks as it dries, it an result in gaps at the seams. Overlapping the seams prevents that.

Wallpaper that is drying and shrinking is also tugging at the wall behind it, which puts stress on the surface. If that surface is unstable, this tension could cause the layers inside the wall to give way and pull apart, resulting in open seams and a delaminated sub-surface. Overlapping the paper redistributes and minimizes the tension, and it also eliminates an open area where the two sides of the seam could pull away from the wall.

A disadvantage of the overlap method is that you can see the cut edge of the paper (see photo), and you also end up with a 1″ wide ridge running under the paper the full length of each seam. In this case, with such a busy pattern, you are not going to see that ridge.