


Some tricks I’ve learned is that you don’t have to wrestle full-length and -width strips. Here I cut the two strips behind the sink horizontally at the point where the vanity hits the wall. I hung the upper strips. Then, moving to the right, I hung the strips to the right. After I ended in the corner to the right (not pictured), I came back and hung the two short strips under the sink. So I was only wielding strips 2′ high, instead of 9′.
I also sliced one strip vertically at the point where it intersected the drain pipe under the sink. This was much easier than trying to wrangle an 18″ wide strip around the drain, two faucets, and the metal support pipes.




Each panel is about 18″ wide, so a 4-panel set gives you about 6′ of width. Panels are about 9.5′ high.

installer, houston, under the stairs