Posts Tagged ‘extra paper’

Have the Paperhanger Measure BEFORE You Order

January 12, 2020

Re the mural in my previous post, which was custom-sized to fit this wall … Folks, you canNOT have a mural sized to fit your wall EXACTLY.

Walls are never a perfect triangle. And they are never perfectly plumb, nor are the ceiling and floor exactly-dactly level.

This means that you have to allow for the pattern to track off-kilter, both horizontally and vertically. And for trimming at the ceiling, floor, and side walls. And don’t forget that the wall may be a different height at the left side of the wall compared to the right side.

The way to accommodate for this is to have a little extra paper on each side. This means ADDING AN EXTRA TWO INCHES ON EACH SIDE of the mural – a total of 4″ to the height and 4″ to the width.

In this case, the company suggested adding 1″ to each dimension. As you see in the photo, by the time I split that 1″ between the top and the bottom of the wall, I was not left with much to play with when trimming at the ceiling.

If this wall had been wider, and if the pattern started tracking downward, I might have ended up with white selvedge showing at the top of the wall, instead of the grey sky of the design.

This project worked out just fine. But, again, it would have been a safer purchase if I had visited and measured this space before the homeowners ordered their mural.