Posts Tagged ‘feather grass’

Test Strips

October 10, 2019


Yesterday, I hung Farrow & Ball wallpaper in another room in this home, and was not pleased with its quality and performance.

The seams were very obvious, due to the thick and stiff nature of the substrate, and to faulty trimming at the factory that left rounded and scalloped edges on the paper. In addition, the paper – which is coated with paint instead of the traditional ink – developed a sheen wherever my brush, smoother, or damp cloth rubbed against it.

So before I started in the powder room today, I did a “test run” by hanging a few short strips cut from scrap paper.

This way I could gauge what I could expect in the way of seams and sheen on this new pattern.

The consensus was that:
~ the seams were again wider / thicker than desirable
~ the seams again did not want to adhere to the wall properly in all areas
~ the ground (background color) developed shiny streaks where my smoothing brush or damp cloth came in contact with it. This was not as obvious as on yesterday’s “Feather Grass” pattern, because the textured raised ink on this “Hornbeam” pattern helped disguise it.

These test strips helped me plan what techniques to employ for today’s installation.

Farrow & Ball Feather Grass

September 1, 2019


Farrow & Ball is a long-established British company. Here is their very unique design “Feather Grass” which I hung in a master bedroom in the country. I love the look of this pattern as you gaze out the windows to the pastureland beyond.

Farrow & Ball includes their own powdered paste, which you mix up with water. To get a smooth mix, I prefer a hand-held blender to the old-fashioned stirrer stick. Not shown is the 1-gallon bucket of cellulose pasted all ready to go.

The company sends a mock-up of what their design will look like. (The image above is from a different pattern I hung in this same home.)

Because their paper is coated with their paint, rather than ink, there can be variations in color as the printer moves through the batch of paint. So the company labels each bolt in the sequence that it came off the printer, and you are instructed to use the bolts and strips in sequence, to minimize any color variations.

This pattern is something like a mural, and comes in panels with one design per panel, rather than strips with multiple repeats of the pattern. In the photo above, I am rolling the paper out on the floor, to get an understanding of how it is laid out and how it is packaged.

Each bolt contained three panels, all rolled up together. The panels are made to fit a wall as high as 12′, so I had to cut each panel from the bolt, then trim it down to fit the 7 1/2′ high walls.

Yes, there is a lot of waste with Feather Grass. In fact, it takes a full strip to go above and below the windows and doors, even though you are throwing away the entire middle part. So, again, incredible amount of waste – I carted home a whole lot of unusable paper to toss into the recycling bin!

Before shot.

The “grass” pattern is meant to appear at about 4 1/2′ from the floor. Since you start hanging wallpaper from the ceiling, I needed to know where to place the tops of the sheaves of grass. So I drew a horizontal line around the room at the 4 1/2′ height. (enlarge photo to see the faint pencil line) This way, from up on the ladder at the ceiling, I was able to see where the tops of the grass stalks were landing on the wall. It took a few trips up and down the ladder on each strip, but I was able to get all the stalks lined up perfectly.

Finished photos. It’s a subtle colorway, so you may need to enlarge the photo to see it well.

Isn’t the overall effect lovely, with the soft misty color of the grass showing against the view of nature outside the window?!

I hung this in the country home (Chappell Hill) of a family for whom I have worked previously in their River Oaks area home in Houston.