Posts Tagged ‘hobby’

Preventing White Wall From Showing

January 23, 2022
Wallpaper expands a bit when it gets wet with wallpaper paste (3/8″ in this case), and then shrinks when it dries. This can result in the white edges of the paper showing, or the wall behind peeking out from teeny gaps. With a dark paper like this, it can be noticeable. I ran a piece of black chalk along both edges of the paper to cover the white substrate (no photo). It’s important to use chalk and not oil pastel, as oil will stain wallpaper.
Then, to keep the the wall from peeping through, I striped the area on the wall under where the seams would fall with black paint. Not shown, I used my heat gun to speed along the drying of this stripe. I don’t make the paint too thick, because you want the wallpaper seams sticking to the wallpaper primer, not to the paint.
All this takes a good bit of time. Also, it’s tricky to plot ahead, because, due to the expansion factor, it’s difficult to know exactly where the seams are going to fall. Non-woven materials don’t expand, but papers like this one will.
I use paint from the hobby store or Texas Art Supply, run along the wall with a small chunk of sponge, dipped in water.

Paint Stripes to Prevent White Wall Peeking Out

January 8, 2022
Sometimes (usually) wallpaper expands when it gets wet with paste and then shrinks just a tad when it dries. This can result in hair-breadth gaps at the seams. Usually not a big deal. But when the paper is dark and the sub-surface is light, you can end up with white wall visible at the seams.
So sometimes I’ll paint a stripe of matching color behind where the seams will lie. Measure to plot where the seam will fall, then use a level and pencil, or a laser level, to indicate where, and then run a stripe of paint along that line. Make the stripe wide enough to accommodate slight variations in measurements and wallpaper expansion.
I use craft paint from the hobby store or Texas Art Supply. The photo shows an outdoor paint – not the best option, but it’s what I had in the truck. 🙂 I use a small rectangle of sponge dipped in water and then in the paint.
For extra assurance, on thick papers, dark surface printed on a white backing, you can also use artist’s chalk pastels (chalk only and NOT oil pastels) to color the edges of the seams. Do a Search here (upper right corner) to find previous posts about that.