Posts Tagged ‘homegenous’

Three-Dimensional Square “Dots” on Pale Neutral Grasscloth

April 2, 2019

Thibaut’s “Union Square” wallpaper pattern is a response to the popular Phillip Jeffries’s “Rivets.” Thibaut’s looser design and pattern placement make it much easier to align with the walls and woodwork – including rooms that are out of square and out of plumb. Which is just about every house in every neighborhood in every state.

The 3-D squares are made of some kind of plastic stuff, and are virtually impossible to cut through with a razor blade or a scissors (such as when trimming at the ceiling door or window moldings). I was able to engineer the room so that I did not have to cut through any of those rivets! Because the PJ pattern is much tighter, this would have been virtually impossible.

Also, I found that my soft short-bristled smoothing brush worked well enough to press the material against the wall while skimming over the 3/8″ high square bumps (sorry, for some reason, the photo did not turn out). But my beloved plastic trapezoidal squeegee smoother was just about useless, because it would not accommodate the 3-D “rivets.” So I had to adjust my install tactics a bit, and figure how to get along without the plastic smoother.

This wallcovering is made of grasscloth, which provides the subtle texture that homeowners are loving these days. But because grasscloth is made of natural fibers, there can be a lot of variations between bolts, and even between strips off the same bolt.

For that reason, Thibaut not only notes the run number of a bolt of wallpaper, but also the sequence in which the material was produced (see photo). The idea is that if you hang strips sequentially, you will see less shading or paneling (difference in color between two strips of wallcovering). Thibaut’s insert also includes a LOT of jargon about the color differences inherent to natural products, and the admonishment to use the bolts and strips sequentially.

I used three double rolls / bolts of grasscloth for this entry. Two of the bolts (the first two in the sequence) were pretty homogenous in color. The room was small and had low ceilings, and so I was able to keep the three strips needed for the longest wall all from the same bolt (#1).

I cut my other full-length strips from the second bolt (#2). That left the third bolt (#3) for the many short pieces needed to go over the four doorways in the room. As you can see from the last two photos, even though it was the same run number and printed at the same time, this third bolt was noticeably different in color from the previous two. The background color is the same, but there is a lot – a LOT – more dark brown fibrous material that got worked into the woven grass material.

Keeping these darker strips over the doors was a good way to minimize this color difference. The strips were only 9″ high. If these strips had been placed side-by-side on an 8′ high wall, the color difference would have been abruptly noticeable.

Color variations are to be expected with grasscloth, or any natural product. But helpful labeling by the manufacturer, and careful plotting by the installer, can minimize these differences.

This ’60’s-era ranch-style home in the Briargrove neighborhood of Houston is very much a “sea of tranquility,” as the whole house is entwined in off-whites, creams, and tans, with various textures like rough wood, sisal, and this grasscloth, used to pull in depth and warmth.

The interior designer on this project is Layne Ogden, of Layne Torsch Interiors.