Posts Tagged ‘inks bleed’

A Nice Faux Grasscloth for Wet Areas – But A Little Difficult to Work With

February 17, 2019


OK, well my “after” shot didn’t turn out, so all I have for you are these close-ups … which do a fine job of showing the texture of this product. It’s made of vinyl, which allows the texture to be embossed into the surface.

In a bathroom, vinyl is a good alternative to real grasscloth, because water splashing on it will not stain it or cause inks to bleed. I run caulk along where the material meets the countertop / backsplash, so that if water pools up along the surface, it can’t be wicked up into the wallpaper (which could cause curling).

This is a fairly thick vinyl on a non-woven backing, and was somewhat difficult to manipulate into areas where it needed to bend – such as pressing tightly against the ceiling or moldings when I needed to trim off excess paper. It took a lot of strength and pushing in order to get a cut that was nice and close to the corner. I just did an accent wall with few obstacles, but this product would have been difficult to work with in a room that had multiple walls to turn around, and things to cut around – windows, cabinets, etc., or outside corners to get the paper to wrap around – you’d probably need to get out the heat gun and spend a bit of time on each such turn.

I used the chalk to color the edges of the dark wallcovering because it had been backed with white material, and also because the edges themselves were a bit burnished.

The faux grasscloth is by Thibaut, and is in one of their new books highlighting textured materials, Texture Resource, Vol. VI. The home is in Oak Forest (Houston) and the interior designer is Stacie Cokinos of Cokinos Design. https://www.cokinosdesign.com/