Posts Tagged ‘joint compount’

Sanding Dust from Smoothing a Textured Wall

October 26, 2021
Bumps from textured walls look bad under wallpaper, and they interfere with good adhesion. To smooth a textured wall, I skim-float with joint compound (a plaster-like drywall material). Once it’s dry, I sand it smooth. This makes dust. In the photo above, the wall only needed a light skim-coat, so the sanding was minimal. Yet, you can see how much dust was generated. On the right is the “tent” of plastic I ran across the wall to prevent dust from getting to other parts of the room.
Here’s a closer look at the powder that has fallen to the floor. And also the sanding sponge I like. The 90 degree corners tend to be too sharp and can gouge the surface, so I take a scissors and trim that off. That’s the exposed red area you see along the edge there.

The next step is to vacuum up all this dust. Then residual powder must be wiped off the wall with a damp sponge, and you have to rinse the sponge frequently. The next step is applying a wallpaper primer. Once that’s dry, the wall is ready for wallpaper.

Treatment for Warped Outside Corner

November 15, 2020

The wall to the left is behind the toilet.  You can’t see it, but there is a wall to the right of the toilet that then wraps around that outside corner you see in the center of the picture.

Wallpaper, especially a stiff non-woven material like this, does not like to wrap around corners.  Most corners are not absolutely plumb, so wrapping around them throws the paper off-plumb, or even causes wrinkles and warps.  The next strip of paper will not butt up perfectly with a warped edge.  

This corner was way worse than the typical corner, because it actually had a bow in it, so it was nowhere near straight.  There was no way that wallpaper would wrap around the corner without warping and going off-plumb

My solution was to split the paper vertically and wrap just 1″ of the paper around the corner.  Then I would cut a new strip of paper, split it vertically, making sure to match the pattern at the corner’s edge, and overlap it on top of the wrapped 1″ piece.

The only problem is that the 1″ wrapped piece had a thickness, so it would leave a visible ridge under the new strip, the entire length of the wall.

So I took some joint compound (like plaster or putty) and used a 1 1/2″ flexible putty knife to run it along the cut edge and wall, evening out that little difference in height.

Once it was dry, I sanded it smooth and primed it with Gardz.  

The ridge is gone, no bump will show, and I am ready to proceed with hanging the new strip to moving to the right.