Before, primed and ready for wallpaper. For various reasons, removing these mounting brackets for the light sconces would have created more problems than it solved, so I left them in place and worked carefully around them. The difficulty is that the sconces are exactly the same size as the mounting plates, so it’s difficult to trim around these plates that jut out from the wall and still get the paper close enough that no gaps show around the base of the light fixtures. When possible, it’s much easier to remove them and put the paper behind them. I chose to center the design on my first strip in between those two sconces, rather than on the faucet. Good thing this is a small and busy pattern, because neither the mirror nor the sink faucet were centered between the sconces. But no one’s gonna notice. If you look in the middle of the photo, you’ll see the vertical red line of my laser level. I’m using this as a guide to place the motifs down the center of the space. Here’s a shot of my laser level. Less than $100 at Lowe’s maybe eight years ago.Finished sink wall. The hooks are for the large, white framed mirror.Window corner next to the toilet. The mint green paint on the woodwork next to the light blue wallpaper print ties this room in beautifully with the other rooms on the first floor of this house. The colors also coordinate beautifully with some artwork in the dining room just steps away.The pattern is called Aboreta and is by Thibaut , one of my favorite brands. It’s a traditional paste-the-paper material , and was nice to work with. Thin and breathable and should hold up nicely in a humid bathroom. This was purchased from my favorite source for wallpaper and for help in finding what you’re looking for – Dorota at the Sherwin-Williams on University in the Rice Village . Her hours vary, so call before you head over.