Posts Tagged ‘neighborhood’

Ditch the Peel & Stick! – Powder Room Re-Do

May 12, 2023
The homeowner wanted a tropical , jungle , palm , sorta wild look for her powder room .   She unfortunately had not read my link (to the right) about the perils and misleading claims re peel & stick “wallpaper.”  So she bought some and attempted to cover the walls in her powder room.
First mistake was purchasing this stuff in the first place.  Second was trying to hang over textured walls .  Third was not having a properly smoothed , sealed and cured surface.  Beyond that, just the concept of peel and stick material is a project doomed to fail.  IMO
Note wrinkles and warps in the material. Paper not adhering .
More wrinkles and warps.  Gap at seam over door .
Paper looked good when she put it up, but seam split / opened within a short time .  This is characteristic of P&S wallpaper , especially if the walls have not been prepped as spec’ed.
So now the P&S has been removed , I’ll step in and skim-float the textured wall to smooth it , prime, and then we’ll be ready for wallpaper .  REAL wallpaper !
Done.  No wrinkles , no warps , good adherence .  She found a pattern that was very similar to her original choice , but more visually pleasing , I think, because it’s less “spiky.”  A good idea of hers was to paint the sink / mirror wall , as this pattern on all four walls could have been overwhelming .
This is a traditional wallpaper , install ed by pasting the paper .   It’s good quality , seams were flat and invisible , and it was nice to work with. 
Close up.
Closer-up.
Just tossing in this photo of how I use a baby’s T-shirt to protect the toilet seat cover .
I guess I forgot to take a photo of the label, but this is made by Designer Wallpaper .  Pattern number is TA20004 .  Oddly, when I Google this, I get pattern names of Jamaica and Tortuga .  And also get the brand name Seabrook .  Wallquest took over Seabrook, but leaving the old brand name on older patterns .
My best suggestion here is, if you want this wallpaper pattern, contact Dorota at the Sherwin-Williams in the Rice Village of Houston (713) 529-6515 .  She is the master at tracking down patterns and all things wallpaper.
The home is in the Timbergrove / Heights neighborhood of Houston .
installer

Shining Gold Trees on Smokey Teal in Hall Bath

March 4, 2023
Before.  A mom and two grade-school girls all vie for space here during the morning routine. 
Note the toothpaste splattered on the vanity countertop .  It was on other surfaces in the room, too.  I had to encourage the girls to be more careful, because substances like this can stain the new wallpaper .
The mom fell in love with this pattern .  What a perfect choice it is for this room! 
It’s perfect with the gold mirror frame, light fixture , towel bar , TP holder , faucet , and cabinet handles . 
Close up.  This is a lightly embossed / textured vinyl surface bonded to a non-woven substrate / backing .  This is durable and stain-resistant stuff , and also should strip off the wall easily and in one piece with no damage to the wall when it’s time to redecorate .  I usually like to paste the paper , but you can also install this via the paste the wall method. 
The pattern is called Shimmering Foliage , and is in the Candice Olson line by York .  I’ve hung it a number of times in various colors , and it’s always gorgeous . 
The home is in the Timber Grove neighborhood , near the Heights area of Houston . 

Dark and Moody Jungle Theme for Powder Room

February 11, 2023




Before. Heavily textured wall has been skim-floated with smoothing / joint compound and then sanded smooth , and then primed with Roman Pro 977 Ultra Prime wallpaper primer . I’ve run a narrow line of dark green craft paint along the top of the chair rail / wainscoting , due to uneven edges . More on that in a soon-future post.
Sink wall is done. Pattern is centered nicely on the faucet and in between the electrical boxes for the new sconces – They haven’t arrived yet and will be installed in a few weeks .
The homeowner’s carpenter created this beautiful wainscoting out of 3D block paneling , and then painted it a rich dark hunter’s green . Right now there’s some sanding dust collected on it, plus bad lighting . In person, it’s gorgeous . The same company did a fantastic paneled wall / fireplace surround in the family room (not pictured) .
Back to wallpaper … This shot is pretty color-accurate. I love the way the dark wallpaper coordinates with the green paneling . The pink and orange flowers , as well as the row of purple foliage , really stand out against all the dark .
Close-up looks like an artist’s painting . Besides centering the pattern on the sink wall, the dimensions worked out so that I was able to balance the chameleons between the ceiling and chair rail , one just below the ceiling and the one here just above the chair rail. So no critter got cut in half .
This product comes as a 2-strip (roll) set , with an “A” strip and a “B” strip in each box. Together, the two strips equal just a hair under 6′ wide , and a little over 9′ high . Here I’m rolling out the two strips so I can gauge the pattern , measure width and height , and plot the layout on the wall.
Sobering fact: Each 2-strip set (one “roll”) cost about $500. This room used four of those sets. I always try to keep that in mind when working with people’s purchased wallpaper .
OK, this damned Word Press blog account has AGAIN (2nd time in two nights!) deleted paragraphs that I spent a lot of time typing. I can’t recreate all the info I put into that lost post, but below I will try to include some of the important points.
First and foremost – since the switch to the New Editor back about 2015, I pretty much HATE WORDPRESS .
Anyway, here the company is providing a mock-up of what the “A” and “B” strips look like. The mock-up above shows the two panels next to each other.
Since this is essentially a mural and the pattern doesn’t repeat vertically as more typical wallpapers do, you can plan on getting only one strip out of each panel. These walls are 6′ high , and the panels are 9′ high. So you’re losing 3′ with every strip.
Further, the area over the door needed one panel that’s 2′ high. But an entire 9′ panel was needed for this, to get the 2′ high strip. So 7′ are going into the trash. Add to that, since this product comes as a 2-panel set , the homeowner had to buy a 2-panel set (at $500), even though only part of one panel would be used. This means that 1 + 2/3 9′ long panels were purchased but not used.
Also, because this comes in panels instead of traditional rolled goods, there are no “extra” strips. This means that I can’t make any mistakes.
Nothing like a little pressure while trying to install wallpaper !
No fears … this pattern and material went up nicely, and we had just enough paper to git ‘er done.


Manufacturer is Breeze and the pattern is called Fantasy Tree . It was purchased from one of the show rooms in one of the Design / Decorative Centers in central Houston. It’s printed on the user-friendly / DIY – friendly non-woven material , which can be hung by pasting the paper (which I prefer) or the paste-the-wall method . It’s designed to strip off the wall easily and in one piece with no damage to the wall when it’s time to redecorate . Definitely better than peel & stick (click my link on the right to read more about P&S ).
The home is in the Oak Forest / Garden Oaks / Heights neighborhood of Houston .

Finished Wall Re-Do – See Previous Post

July 26, 2022
Here’s the wall after I stripped, sealed, skim-floated, sanded, and primed it.
Finished. The birds in the pattern balanced nicely with between the ceiling line and the wainscoting.
I had more success with this install than the previous guy, due to proper prep, and also the material used this time was the user-friendly non-woven , rather than the old fashioned pulp type wallpaper the other guy had to wrestle with.
Strawberry Thief is a very popular pattern right now, and comes in many colorways. Do a Search here to see my other installations of this design.
There were some issues at the top of the wainscoting where the painters had used tape to mask off areas, long with caulk, an it left a rather large (1/8″) unpainted area between the wood molding and the wall. I filled this in with joint compound and primed it, and wallpaper would have adhered just fine. But that would have left a white gap between the wallpaper and the green molding.
I rummaged in my truck for the best matching paint I could come up with, and painted over the white edge. This would have left a bit of a thin brown line between the wallpaper and the green molding. It would have looked OK, but I had an idea to get rid of the gap altogether.
If I had used my regular thin straightedge (the red one), it would have let me trim the bottom edge of the wallpaper nice and close to the wall. But that would have left the aforementioned brown line showing.
So I used the metal plate you see at the upper right of the photo as a trim guide. It’s thicker than my red straightedge, and so gives a fat cut that leaves more wallpaper and less of that brown line.
In fact, the left edge, as you can see, is rolled, and that creates an even thicker edge to trim against, leaving even more wallpaper at the bottom of the cut. See the photo just above, to see how the wallpaper now completely covers the brown line.
These metal plates have a lot of other uses. They are made and sold by a fellow member of the Wallcovering Installers Association . She makes a lot of other cool tools, too. If you are interested, send me an email. wallpaperlady@att.net
The wallpaper design is by William Morris , a famed artist of the Arts & Crafts / Art Nouveau periods . The brand is Morris & Co.
This label is EXACTLY the same as the pulp material the original installer worked with – save for that one word non-woven . Be sure you get the non-woven version, which is also called paste the wall .
The home is in the Heights neighborhood of Houston .