Posts Tagged ‘pebbled’

Challenges With 40″ Wide, Thin Vinyl Mural

March 13, 2021

See other recent post(s) for more info on this material and its install.

When ordering, from the materials offered, the homeowner chose this vinyl option, because she loved the slightly textured, “pebbled” surface. I would have much preferred she went with the more predictable and cooperative non-woven material.

The instructions said to paste the wall. Which is what I did. But I believe this material would have performed better if they had said to paste the product.

Pasting the product would have evened out moisture absorption from the paste, as well as expansion as the substrate wetted-out. That may well have eliminated the wrinkles you see in the photo.

It took a lot of patient work with both the smoothing brush and the plastic squeegee to work these wrinkles and bubbles out of the wallpaper. The resulting flat surface was not necessarily the Holy Grail … because often the far edge of the wallpaper will get distorted and / or warped / bowed.

It’s really difficult to hang a new, subsequent strip next to a strip with a warped edge. It’s hard to butt the seams, and plus additional strips get more and more warped. Eventually, you get to where the resulting wrinkles are so large that you cannot work them out.

This is one reason why you start hanging from the midpoint of the wall. This helps disperse any such wrinkles or other imperfections equally across both the right and the left sides of the wall.

I was lucky that I had only four panels and three seams on this install.

As mentioned above, a non-woven substrate would must surely have eliminated the wrinkle problem. Non-wovens are made of synthetic fibers (including fiberglass), so they do not expand when wetted by paste or water. So you can paste the wall and then apply the wallpaper, without worries about the paper stretching out of shape

World Map Mural, Kids’ Play Room, Heights

March 11, 2021

This family loves to travel, so a world map that covers a full accent wall is the perfect backdrop to the kids’ play room.

The brand is Wallartica. It is a lightweight vinyl with a pebbled textured finish (see close up photo).

I hung it using the paste-the-wall method.

The panels are 40″ wide, so stepping across the two ladders helped me handle that wide width material.