Posts Tagged ‘perfectly’

Using Laser Level to Position First Wallpaper Strip

October 24, 2021
Here I’ve measured the wall and the wallpaper, and the design, and plotted where I want my first strip to hang – in this case, with a vertical line of the wallpaper smack in the center of the wall. The black object you see in the foreground is my laser level, and it’s shooting a vertical red line onto the wall, right where I want my first strip to land.
Here I’ve positioned my first strip along that vertical laser line. This ensures that my strip is perfectly plumb.

Skooshing to Better a Kill Point

September 22, 2020


Re the dining room in yesterday’s post … a kill point is the point in a room where your last strip of wallpaper meets up with your first strip. This virtually always results in a pattern mis-match. So we try to put it in a corner behind a door, or some other spot where it won’t be too visible.

But this room (see yesterday’s blog post) did not have any hidden corners. If I had placed the kill point in one of the four corners, you would have had an eye-jarring, 5′ long pattern mis-match.

The areas over the doors and windows were only about 5″ tall, and way up high, so are not very noticeable. Especially the one over the entry way, because people’s eyes are focused on the far wall. So I decided to put the kill point there.

In the top photo, about 1/3 from the right, the pattern ended only about 1/2″ from matching perfectly. To be honest, this is not a bad look, and would have been acceptable as a finish point.

But I knew I could make it look better.

I took the piece to the left and cut it apart, following the curvy design. I made two such cuts, turning it into three separate pieces.

Then I skooshed the pieces to the left, overlapping that excess 1/2″ (divided between the three strips).

In the finished photo, you can’t tell that the original pattern doesn’t match perfectly, nor that some of the motifs are 1/4″ narrower than they were originally printed.

From the floor, this kill point is undetectable.