A Second Centered Wall In the Same Room – Tricky Feat

Re my previous post, about centering the pattern on the fireplace wall … Once a wallpaper pattern has been positioned on the first wall, as subsequent strips are placed around the room, the pattern falls in its proper sequence. Meaning, you have no control over how the design will land on all the other walls.

In this room, I felt it was important for the design to be centered on the fireplace wall (see previous post). But the headboard wall was equally visually prominent, and it would sure look best if the scalloped design could be centered on this wall, too. But the way the wallpaper strips were following each other, the pattern would fall off-center when it hit this wall.

I thought I could make it look better. It took careful engineering, precise measurements, a laser level, some secret tricky techniques, and a whole lot of time (coupla hours). But I got the swoopy design centered behind the bed and between the windows and light fixtures, so the whole area looks perfectly balanced.

To achieve this, I had to ” shrink ” the design above and below the windows. (Do a Search here to see other posts explaining this process.) And I did end up with a pattern mis-match in the corner to the left (sorry, it’s not visible in this photo). But I figured that a mis-match in a corner 17″ from the floor, plus a 4″ high section over a window were a fair trade-off for that beautiful symmetrical headboard wall.

For the record, I worked it out so that the mis-match in the corner was only about 1.5″ off from the actual match. No one’s gonna notice! So sorry I forgot to photograph this.

I will say that the features of this room, as well as the way the pattern was printed on the wallpaper, plus the pattern itself, helped immensely to achieve this balanced outcome.

The design is called Versailles and is by Schumacher.

Using Laser Level to Position First Wallpaper Strip

Here I’ve measured the wall and the wallpaper, and the design, and plotted where I want my first strip to hang – in this case, with a vertical line of the wallpaper smack in the center of the wall. The black object you see in the foreground is my laser level, and it’s shooting a vertical red line onto the wall, right where I want my first strip to land.

Here I’ve positioned my first strip along that vertical laser line. This ensures that my strip is perfectly plumb.