You’ve got to look at this close-up, to notice the antelope and flames / foliage . You gotta make a decision … The light sconces (they are currently removed, but you can see the electrical boxes where they will be placed) were centered on the vanity top, but the faucet was off-center by about an inch. So I chose to center / balance the pattern on the sconces and countertop. The mirror will be hung between the two light fixtures, so we’ll end up with a pleasing, balanced look. The faucet isn’t exactly in the middle of the design motif, but no biggie – there’s going to be a mirror there, anyway.
t
Corner going around shower. Note the window looking into the shower. Although the website specs said this is a pre-trimmed non-woven material , that was incorrect. Turns out it had an unprinted selvedge edge that had to be trimmed off by hand . Here I’m using my straightedge and razor blade to remove this selvedge. This takes precision and a LOT of time . The manufacturer usually provides trim guides to help you know where to cut. But it’s usually better to trim to the pattern – determine an element in the design motif that will meet up with the corresponding motif on the opposite side of the strip when the strips are hung on the wall, and use that as your guide . Be sure to trim off the trim guide marks, or they will show on the wall. The pattern is called Arabian Nights and is by Relativity Textiles . I’ve never worked with this brand before. I was not pleased . In addition to the incorrect information about the pre-trimmed paper , the mfgr’s specs said this was printed on a non-woven substrate . It was not. It wasn’t even printed on standard wallpaper stock . Instead, it was a pulp material – This is a sort of old-fashioned wallpaper , and is very brittle and prone to tearing and dragging (your trimming knife or razor blade will get snagged and you’ll end up with a ” chewed ” jagged cut, instead of a crisp cut . It also tears easily. It also has no coating, so it’s not stain-resistant … Not good in a busy household with a 3-year old toddler , or anyone splashing water or soap or air freshener . It was also difficult to hang . Applying wet paste to the backing causes the substrate to absorb moisture and expand at a different rate from the ink on the surface. So you end up with wrinkles , waffling , and quilting . Sponging a light bit of water on the front before pasting helps even out the moisture differential and ease installation . I’ve never before encountered a pulp that had this type of ink on the surface. One clue for this bad stuff is when you open the package and it smells like moth balls . Once I figured out how to work with it, , it went OK – although tedious . The seams did look very nice. BUT … all this effort would have been unnecessary and the finished room would be more durable if the mfgr had printed on a non-woven substrate (as their on-line specs stated) and had used standard inks instead of this weird , smelly , high-end stuff. In fact, the material would have cost the homeowners a whole lot less $ if it had been normal ink on a non-woven backing . The home is in the Woodland Heights neighborhood of Houston . installer
Some wallpapers (usually the higher-end brands) are not pre-trimmed at the factory. They come with an unprinted selvedge edge, much like fabric. This needs to be trimmed off before the paper can go up on the wall.
If you’re lucky, the manufacturer will have provided printed trim guides / marks. And if you’re really lucky, the trim guides will be “true” (accurate).
Trimming off this selvedge takes concentration, precision, and the right tools. Here you see my table, protective polystyrene strip, brass-bound straightedge, plus a good old trusty single edge razor blade.
The Wallpaper Lady's Blog 