Don’t Use Adhesive Picture Hangers

Yes, they’re strong enough to hold a 50lb painting.

But removing them may well take layer(s) of paint along with! Here you see a bubble that has lifted from the wall, as well as a break in the paint that was torn off by the adhesive picture hanger.

Several layers of paint have been pulled away from the wall. This is called ” delaminating .”

One reason for this is because the original underlying surface may have been dusty – as in dust from construction, or from sanding new drywall joint compound. Nothing sticks to dust. Other reasons for delaminating walls are incompatible surfaces, such as, an older home that starts out with oil-based paint, then someone comes along and applies latex paint over it without proper prep, then someone adds a gloss paint, then a ” flipper ” buys the house and slaps on a coat of paint without deglossing, ,,, on and on, situations that can cause layers of paint to not stick to each other. End result is that the wallpaper may come away from the wall, too.

Improper Prep Leads to Failed Wallpaper Job

The new homeowners bought an adorable 1920’s home in the Woodland Heights neighborhood of Houston, and inherited a dining room with a beautiful wallpaper pattern – that unfortunately had not been hung properly. The wallpaper was curling at the seams, peeling away, and literally falling off the wall. It is taking chunks of a white substance along with it.

It’s hard to determine exactly what is causing the failure, but the first issue is that the underlying wallpaper was not removed. Since wallpaper has an acrylic coating, it does not provide a secure foundation for the new paper to adhere to. In some cases, it’s not possible to remove the old paper, and then the seams should be floated over, and the old paper should be primed so it will have a surface that the new paper can grab ahold of.

Here, it looks like the walls were either not primed at all, or were primed with a flat wall paint. Some of that paint is letting go of the old wallpaper and pulling away from the wall, which allows the new paper to fall off.

Ideally, that striped ’90’s paper should be stripped off, along with any other layers of paper underneath. But it looks like some of the underlying paper was floated over, and that makes it particularly difficult to remove.

I suspect there are other issues going on, so it will take some time and exploration to decide what will be the proper approach for removing the beige paper and then prepping the walls, before the new homeowners’ new paper can go up.