Posts Tagged ‘removing’

Doing the Opposite Today – Removing Wallpaper

September 30, 2020


The large medallion on soft lavender on all walls of this large bedroom worked well for this gal for many years – but now that she’s an older teen, it was time for an update.

So instead of putting wallpaper up, today I took it down.

Most people think that stripping wallpaper is difficult. But if the walls were prepped properly, and if the paper was hung properly, and if the proper removal steps are followed, it should all go well, with minimal damage to the walls. See my link at right, on how to strip wallpaper.

The most important thing is to separate the top, inked layer of paper from the backing / substrate layer. I find that wetting this top layer with a sponge and plain water helps strengthen the fibers, so the top layer can be pulled off in larger strips.

In the second and third photos, you see how the purple layer has been stripped off, leaving the white backing attached to the wall. This top layer has to be removed, because it has an acrylic (or vinyl) coating, and will not allow water to pass through it.

The next step is to soak the backing with plain water and a sponge (see photo). No chemicals, no additives – just plain warm water. You will have to reapply water several times. The idea is to let water soak through this backing layer, to reactivate the paste underneath. Once that paste is good and wet, it should release from the wall. Sometimes you have to gently scrape the backing from the wall. But in my case today, once that paste was reactivated, the substrate layer came away from the wall in full, intact sheets. Easy peasy!

One photo shows my “dull” 3″ stiff putty knife. I call it “dull,” because it’s old and beaten up. But it’s really rather sharp. I use it to carefully get between the inked top layer of wallpaper and the bottom substrate layer. And then I use it to gently scrape wallpaper from the wall.

In my case today, the previous installer had done a superb job of hanging the wallpaper. He applied a primer before hanging the paper. That primer helped make this whole removal job go well, and it protected the walls from damage.

The family will need to apply a stain blocker to prevent any residual paste from causing the new paint from crackling or flaking off. Once that’s dry, the walls can be textured and / or painted. The room’s resident told me that she is planning to go all white.

This home is in the West University area of Houston.

Stripping Wallpaper

December 26, 2016

Digital Image

Digital Image


Today I repapered a powder room that I have done at least twice before, over 20 years or so. The existing paper stripped off easily, in part because it was a pre-pasted paper-backed solid-vinyl paper, and also because of the primer I used to seal the walls – oil-based KILZ Original. The primer protected the walls and kept them intact, and there was no damage to the walls whatsoever.

The photo shows all steps of removing this kind of wallpaper. The printed top vinyl / plastic layer is pulled off. With this kind of paper, the top layer usually separates and pulls off easily and in large pieces. This leaves a paper backing still stuck to the wall. This is the light tan area you see in the photo. I use a wet sponge to soak this layer. When it gets good and wet, it turns dark tan, as seen in the photo.

The next step is to remove this backing. Once it’s good and wet, the paste holding it to the wall will reactivate, and the wallpaper will peel away from the wall easily and in large pieces. Sometimes it might be necessary to scrape the paper off the wall, which can be done with a not-too-sharp 3″ stiff putty knife, taking care not to gouge into the wall surface.

Stripping Off What I Hung Not Long Ago

May 25, 2016
Digital Image

Digital Image

Digital Image

Digital Image

Digital Image

Digital Image

Digital Image

Digital Image

Digital Image

Digital Image


About four years ago, I hung wallpaper for a young couple in a home they were renting in Montrose (Houston). Now they have bought their own home, and they have to leave the townhouse in the condition it was when they first moved in – so the wallpaper has to come off. 😦

The geometric at the top was an accent wall in a home office, the soft trellis was in their dining room (the dark spot is where I have wet it to start softening the paste as part of the removal process), and the large motif was an accent wall behind their bed in the master bedroom.

All the papers are coming off fairly easily, with minimal damage to the walls. That is thanks to the good primer I put on the walls before installing the paper. 🙂