Posts Tagged ‘repipe’

Going For More Of The Same

February 9, 2021

I hung the original wallpaper in 2014, when the house was first built. The PEX water lines used in the home (flexible hoses instead of PVC pipes) were new at the time. Tragically, after a few years, the lines used in this home failed and caused leaks all over the house. Replacing all the water lines required cutting holes in MANY places throughout the home.

You can see in the photos where the plumbers cut out drywall and then patched it back in. This company actually did a good job of removing the wallpaper in the areas of their repairs.

Unfortunately, with the amount of wallpaper that was left over from 2014, I was not able to do repairs. The entire room had to be repapered.

The homeowner loved the pattern and wanted to keep it. It was still available, so she bought enough to repaper the room.

For various reasons, the original wallpaper was much more difficult to get off the wall than I expected. I could have gotten it off – but it would have taken about two full days.

So I opted to hang over it. It’s important to skim-float over the seam areas. First, because the seams will leave a little ridge that will telegraph through and show under the new paper. But also, because as wallpaper dries, it shrinks and puts tension on the seams. There is always the potential that this tension will cause the the surface below to pull away from the wall, and especially so if there is a weak area such as a seam. So you always want to avoid putting a seam on top of a seam.

So I skim-floated (do a Search here to learn more) over the seams, as well as over the patched areas left by the plumbers. See photos. Then I sealed the walls with Gardz, a product that penetrates and seals porous materials – like drywall joint compound and like this traditional British pulp wallpaper. Because it soaks in and dries hard, it helps to prevent moisture from paint or wallpaper paste from soaking through, and thus prevents bubbling of the underlying surface. That’s why this product is primarily used for sealing torn layers of drywall.

Although a bit glossy for my liking, Gardz is also a good primer to hang wallpaper on.

Interestingly, the expansion rate of the new wallpaper was a bit less than the original, and so the seams fell about 1/4″ to the right of the original seams. This reduced the worry of seams falling on top of seams and causing lifting.

It was a complicated room, and the paper was thick and stiff and difficult to work with. Prep took one day, and it took me two additional days to hang the paper (16 single rolls – 8 double roll bolts).

The wallpaper is in the line of Nina Campbell, by Osborne & Little, a British company. While most British papers these days are printed on an agreeable non-woven substrate, this one is a traditional, old-school British pulp … thick, stiff, difficult to fit into turns and angles, easy to tear, easily stained, non-malleable, plus the factory’s trimming roller blades must have been dull or wobbly, because the edges were not cut perfectly straight, which meant the seams had some “gaps and overlaps.”

Still, the finished room did look pretty darned good – even if it looks exactly the same as it did in 2014.

But that’s exactly what the homeowner wanted. So all is good and mission accomplished!