Stabilizing Section Over Door

I wanted to position this pattern so that the stripe ran right up along the right side of the door frame. That would be more visually pleasing than having half-sections of those angular motifs.
The stripe did run along the outer edge of the wallpaper strip, so I could have easily butted the edge along the door molding.
But that would have put a vertical seam running right up over the corner of the door. My experience has shown that this area gets a lot of stress, especially in the case of shifting foundations and walls. So I really avoid letting a seam fall there.

My solution was to take a strip and move the seam over – easy to do with this striped pattern.
We had very little paper for this job, so before cutting anything I made sure that reducing the width of this strip by one section of diagonal motifs would still allow me to reach the corner on the far right (not shown).
So I measured down a little more than the height of wall above the the door and kept that intact and full-width. The rest of the length of that strip I cut along the strip in the design, all the way down to the floor.
Here that strip is in place. Leaving the top portion a little long ensured that I had enough to cover this area, and then all I did was trim off the extra 1″ or so, just as you normally would trim around a door frame.
The best part is that we now have the paper reaching across that “danger zone” above the top right corner of the door, with no seam to split open or gap should the wall shift.

Here’s a close-up of the irregular strip as it falls alongside the door molding.

Here’s the left corner of that door. I did some tricks to get that strip straight along the edge of the door frame, too. No pics, but, in a nutshell, I cut vertically along the lines in the design over the door, to cut the sections apart. Then I overlapped the sections about 1/4″, with the vertical stripe disguising the overlap. This made each section of diagonal motifs narrower. Once I had narrowed the whole area by removing about an inch, I had pulled the full-height strip on the left over to the right far enough that the tan line lined up along the door frame, and above the door it butted up with the left edge of the last section of diagonal motifs.
Note that this is a very easy pattern to play tricks with, because, although there is a pattern match, it really doesn’t matter much if you ignore it. Also, the lines are not perfectly straight, but a bit squiggly, and that makes it much more forgiving.
In fact, because we were really short on paper, the only way to get the room done was to mis-match the design in most places. The homeowner was OK with that. In fact, she (and he) were delighted with how the room turned out.

This very popular pattern is called Feather and is by Serena & Lily . Just about everything they make, I love hanging. (not so fond of their non-woven / paste-the-wall option) This comes in many colors, and you can purchase directly from them on-line.
wallpaper installer houston