Posts Tagged ‘skim-coating’

Smoothing Over A Mess

August 3, 2022
This kind homeowner had the sink / vanity in this powder room removed. This makes it a LOT easier and faster for me to to get the wallpaper up, and with less stress on the paper and fewer relief cuts .
Removing a sink that’s attached to the wall often damages the surface. Here you can see how the workman used spackle compound to cover the torn drywall and other damage.

s

Close-up. This isn’t a very smooth surface, and the wallpaper will have a hard time grabbing ahold and adhering. It’s also way too porous and crumbly to support wallpaper.
In the top photo, you see where I have applied smoothing compound on the upper portion of the wall. I’m working my way down.
Once it’s dry, I will sand and prime it, and it will be nice and smooth.
Here’s a shot of the fresh smoothing compound, before sanding.
Some people use a drywall taping knife or a broad knife to apply the plaster-like substance. I prefer the trowel you see in the photo, because it gives me more control and precision.
The 2″ flexible putty knife is for getting into smaller areas. The 3″ stiff ” Hyde ” putty knife is for knocking off high points or bumps on the wall before applying the smoothing compound.
This process is called skim-floating or skim-coating .
I like to use the Plus 3 lightweight joint compound made by Sheetrock . We just refer to it as mud . Find it in the drywall aisle.
The Plus 3 spreads on easily enough, sands easily , and the dust falls to the floor where it can be vacuumed up easily – as opposed to getting air-borne and drifting all over the place.
This box, which is approximately one cubic foot , weights 32 pounds . Ugh. Try carrying that across a parking lot and then up to the third floor of a townhome!
I like to transfer the material to a 5-gallon bucket. This is what it looks like in the bottom of the bucket.
Easy to scoop out. When I’m finished, I use a wet hand to smooth down the surface, wipe residue off the sides of the bucket, then place a thick sheet of plastic over the surface to keep air from drying it out. Then, of course, I put the lid onto the bucket.

Smoothing Walls – I Can’t See What I’m Doing!

September 15, 2021
To smooth textured walls so you won’t see bumps under the wallpaper, I use this trowel to spread on Sheetrock brand Plus 3 lightweight joint compound (a.k.a. “mud”). This is called “skim-coating” or “skim-floating.”
Problem is, the mud is the same color as the wall. I can hardly see what I am doing! Once it dries it will turn white. But until then, I’m fumbling along.

Textured Wall Now Nice and Smooth

May 11, 2021
“Orange peel” texture on wall
Same wall smoothed and primed and ready for paper

You don’t want to hang wallpaper on a textured wall. The bumps will show through and look bad. Plus they impede good adhesion.

I’m pretty darned good at smoothing textured walls, through the skim-floating or skim-coating procedure. You can do a Search here to read more.

Note: The slight texture in the second photos is from the roller that applied the primer. The photo is magnified many times. In real life, this wall is nice and smooth and ready for wallpaper.