Posts Tagged ‘staircase’

Small Under Stair Segment

September 1, 2020


Just a tad of the underside of the home’s curved staircase jutted into the under-the-stairs powder room. The homeowner and I considered leaving the underside white, like the ceiling. But we decided it would look better to have all surfaces covered with the wallpaper.

Getting wallpaper onto both surfaces of this element presented some challenges. First, the curves and irregularity of the drywall work meant that paper would likely twist and warp and go off-kilter. Next, the underside was not perfectly flat, so there was the likelihood of void areas where the paper would not stick to the surface. Also, the curves and angles mean that the design will be torqued off-plumb, leaving the animal figures crooked and also not straight along the ceiling line. Finally, you can only match the pattern in one place, so that means that we would be left with mis-matches in three of the four corners / junctions.

Luckily, this pattern was extremely amenable to looking good even if it went off-plumb, tracked away from the ceiling line, or didn’t match perfectly. In addition, the SureStrip line (by York) is very flexible and malleable, and it adheres well with minimal shrinking, even on a surface with undulations.

I decide to match the pattern at the bottom of the sloped wall, where it meets the vertical back wall. Since this wall was a little higher on the left side than the right, it angled the new strip above it a bit to the right. Not a big deal … It’s only 27″ high, and no one is going to notice that the animal motifs are leaning a tad. And definitely no one is going to notice that the vines are not perfectly vertical.

Note that before applying paper to the underside of the slope, I wrapped 1/4″ of the paper from the horizontal area onto the underside (photo 2). This does create a slight ridge when the paper is applied to the underside and overlaps onto this 1/4″ flap. But I like this method, because it creates a nice, tight bond, and it eliminates the possibility of gaps showing if the two surfaces of wallpaper were trimmed flush to the corner of that rounded edge (which is not absolutely perfectly straight).

So, speaking of that slightly rounded edge, as well as the one to the left of the slope, in both these areas, the wallpaper pattern could not be matched. Not a big deal. It doesn’t assault your eye at all. I’m very pleased with the way this turned out.

On to other things. In the upper left, you might notice that there are two monkeys next to each other. This is just a result of the way the pattern worked its way across the wall, after being fitted to walls moving back into a 90* angle, and to walls moving forward in a curve. I did do a little cutting along the vines, so the slight mis-match would be less noticeable than if it were a straight vertical break in the pattern.

You’d have to spend a lot of time looking up behind you at that exact point to even notice that the two monkeys are closer to each other than they “should” be.

Later, I did go back and use scrap paper to cut an appliqu̩ of a rabbit Рalso trimmed along the wavy lines of the foliage Рand pasted this on top of the monkey. Sorry, no photo. But seeing a rabbit instead of an ape successfully broke up the repetitiveness of the dual monkeys. Now, all you see are happy animals in a forest.

Crazy-Making Undersides of Staircase

August 12, 2015
Digital Image

Digital Image

Thank goodness the designer agreed with me to NOT paper each of these four boxes, on the ceiling of an under-the-stairs powder room. Usually, the undersides of the staircase is finished off with a sloped ceiling.

Wallpapering a sloped ceiling is relatively easy. But if I had had to put wallpaper on each of these 3-strip wide, 2-sided, curving boxes built around the individual stairs, it would have taken a good couple of hours, not including the prep.

The interior designer instead had a painter put gold paint on the boxes, which will look fabulous with the wallpaper – more pics tomorrow!