More Blue Heron Flight Mural

This is the kind of a room that you don’t just look at the walls – you have to stand in the room and feel it. Dusk settling into night , swooping birds , stormy clouds .

This looks a little like hand-stitched embroidery .

This textured natural material is a fine sisal , which is similar to grasscloth . The color between panels was pretty uniform , as you see at the seam toward the right of the photo .

These panels came 33″ wide . But for this last strip on the right, I only needed 23″ width. That means I would have 10″ of width , the length of the strip, to cut off and discard . If I had used the left side of the strip, which is logical installation sequence , we would have had birds’ butts sticking out from the side of the window molding . So I decided to trim off that left side and instead use the right side which, as you see, has a more pleasing bird’s face and wing .

The brand is Phillip Jeffries , a high-end company . The material comes as a 6-panel set . You have to purchase six panels, but after that, you can buy individual panels in sequence, so you’ll have enough to do your room , without having to purchase a full 6-panel set. Like I said – this stuff is pricey!
This dining room is in a renovated 1925 home in the Heights neighborhood of Houston .
installer

Phillip Jeffries Flight in Blue Heron in Heights Dining Room

Before shot of dining room in a beautifully restored and enlarged 1925 bungalow in the Heights neighborhood of Houston.
Just below dead center of photo, under the stairs – my helper couldn’t be less interested!

Swooping heron , and powerful , roiling, turbulent clouds .

This is a manila hemp product , which is similar to grasscloth , and has a texture d surface . As with most natural materials , the seams are always a bit visible .

The walls in this home were smooth , so no call for skim-floating or sanding … Just a primer was needed . My favorite primer for wallpaper is Roman Pro 977 Ultra Prime .

This wallpaper comes in panels , and is custom made to order . All of the panels are rolled up into one long bolt , and you have to separate them, as you see here. AND keep them in the correct order / sequence ,

I was lucky that this house had a lot of open floor space , where I could roll out the panels to verify pattern match, panel sequence , and get accurate measurements.
Note that, like many high-end brands, this wallpaper comes with an unprinted selvedge edge , that has to be trimmed off by hand . Once I get the edges trimmed off , the birds you see in the photo above will match perfectly .

I trim against this Big Blue straightedge , and hold a single edge razor blade in my hand .

Sorry, I don’t know how to flip this photo. WordPress used to be easy to work … but some years back they came up with this ” New Editor ” which is, to be honest, a nightmare, and costs me a lot of time every evening.
End of rant. Here is a mock-up provided by the manufacturer , that shows the mural as a six- panel set , including pattern layout and dimensions of each panel .

Here are my drawings from when I first consult ed with the homeowner and we plotted out how the paper was to be install ed. Phillip Jeffries is expensive stuff!
Normally, with a mural , a full-height panel is required for even the 6″ high areas over the door ways. See photo below. This means that you’re paying for a lot – a LOT – of wallpaper that gets cut off and thrown into the trash.
But, since the panels are about 2′ taller than the walls , we figured that the part cut off the bottom of each strip could be used for the areas over the doorways (see next photo) , as well as above and below the windows (see last photo).
This will take no small amount of math and engineering , and the couple will have to live with some paneling / shading , and color variations between strips . But that’s typical of grasscloth type products , anyway. Accepting a few color differences will save this couple a few – thousand – dollars. Yes, I told you that PJ was expensive stuff!
And I’m up for the challenge !

Here’s the one area I’ve done so far, using scraps discarded from the bottoms to piece in over the top of the entryway . This area is only 6″ high , so color variations won’t be very noticeable . Still, it really turned out well.

Getting a similarly pleasing look on this wall , with heights over and under the windows being much higher than 6″ , will be tomorrow’s challenge. Stay tuned!

Swallowtail in Heights Dining Room

This is a beautifully renovated and updated 2-story 1920’s bungalow in the Heights neighborhood of central Houston.
Unlike the trend for homes that are all white or grey , this family went for color and fun . In other rooms, the woodwork and walls are painted cheery yet soft shades of blue , orange , yellow , salmon , and green . You may be able to find some photos by doing a Search here.

The fun doesn’t stop with paint colors … Here is a colorful and visually active wallpaper pattern in the family’s dining room .

The pattern might be overwhelming floor-to-ceiling , so the board and baton wainscoting gives the eyes a resting place.

The pattern is called Swallowtail . Not sure if that refers to birds or butterflies , but either way, it’s a fitting description .

You can almost feel the swooping and swirling wings .
The homeowner chose sconces that coordinate beautifully with the theme of the wallpaper .

The manufacturer is Flat Vernacular . The material was pre-trimmed , and was printed on a non-woven substrate . It could be hung by pasting the paper or by pasting the wall (I pasted the paper, as I usually do). It was nice to work with.
Unlike most wallpapers that come in rolls of standard dimensions , this material was priced and sold by the yard , and came in bolts of continuous lengths .