Like most of them, this toilet is set too close to the wall for my smoothing brush or hand to be able to reach behind and press the wallpaper against the wall . Don’t want the homeowner to have to hire a plumber to remove the tank , and then come back to reset it. $$ So here’s an improvised trick … I’m using a length of yardstick that will easily slip behind there. It’s long enough that I can grab either side and slide it behind the toilet tank , pressing it against the wall. BUT … the flat yardstick isn’t always able to push the wallpaper against the wall, because walls are never absolutely flat . So it helps to add some cushioning that will help fill that void. Here I’ve wrapped my microfiber rag around the wooden stick . This adds just enough thickness , while also being cushy enough to press into recessed areas. I unwrapped a bit, because the original attempt was a bit too thick to fit between the toilet tank and the wall. The wallpaper pattern is called Jamaica and is by Designer Wallpaper . I install ed this in a powder room in the Timbergrove neighborhood of the greater Heights area of Houston .
Powder room before. Note the blue ceiling . I applied a white pigmented wallpaper primer ( Roman Pro 977 Ultra Prime ) to the walls . Done! So cheery and fun and lively! These flowers just make you smile when you walk in here!Toilet corner before. I’m grateful to the husband for removing the toilet tank, as well as the sink / vanity. This sure saved me a lot of time and squeezing into tight spots. The red square in the back is wall area that was blocked by the toilet tank, so previous painters were not able to reach that area. It had a heavy sand texture on it, which I took a little extra time to skim-float and then sand smooth. Nobody’s going to see it, but it will help the wallpaper adhere better . Toilet corner after. The corner you’re looking at was off-plumb by about 1/2″ from top to bottom, so there is a bit of a pattern mis-match as you get closer to the floor. Not a biggie with this wild pattern, plus it’s mostly hidden behind the toilet.Hard to see, but the focus of the photo is an angled wall under the stairs . The blue ceiling coordinates perfectly with the colors in the wallpaper . This is by Rifle Paper , and is called Garden Party . Every Rifle Paper I’ve hung previously has been on a non-woven substrate , and could be installed by the paste-the-wall method. The label said this was a PTW (see diagram of brush putting paste on the wall) … but it surprised me, because it was NOT! It was on a regular paper stock, and I’m betting it’s the same material that York prints its SureStrip line as well as the Spoonflower brand. I assumed the directions and diagram were correct, so first I pasted the paper and then took it immediately to the wall, with no booking time. Lo and behold, I got bubbles on the wall. This happens because the paper is absorbing moisture from the paste and expanding. With no way to escape being trapped between the paper and the wall, the moisture ” off gas es” and pushes away from the wall ,,, resulting in those bubbles. My solution was to treat the material as a traditional pasted wallpaper. So I pasted the back, folded pasted-side-to-pasted-side (called booking ), and then placed it into a black plastic trash bag for a few minutes. This allows the paper to absorb moisture from the paste, expand, and relax , all before it goes onto the wall. This is a pretty sure way to prevent the appearance of bubbles or blisters or wrinkles. The townhome is in the Highland Village / Galleria area of Houston .
The Wallpaper Lady's Blog 