Posts Tagged ‘turn’

Using Heat To Bend Vinyl

September 3, 2022
I will be wrapping a stiff , thick , embossed textured vinyl wallpaper around the inside of this window return . This 90* angle is called an outside corner . This is tricky enough.
But the real feat will be wrapping the material around that bend , and getting it to adhere to that little lip on the bottom next to the wainscoting – which is only about 1/4″ deep . That doesn’t give much for the paper to grab hold of, especially since it is stiff and will want to retain it’s flat position .
Heat gun to the rescue! Heat will cause the vinyl to soften and allow it to bend . This is my test piece. I’m experimenting with how much heat is needed and the delicate balance between bending and melting or burning .
Also how much time is required for the vinyl to cool and how well it will retain its new shape , and how firmly it will adhere to that little narrow 1/4″ lip .
Because I can’t safely put my hands in front of the heat gun, and my plastic smoother tool would not hold up, I use this ” Euni Plate ” of stainless steel , which was invented and manufactured and sold by a colleague of mine in the Wallcovering Installers Association WIA .
Here’s another view. The plate has angles and rolled edges for various uses. The damp cloth is to quickly cool the vinyl, in hopes to keep it in the bent shape .
Another trick is to use a straightedge and razor blade to gently and lightly score the vinyl along the outside of the corner fold , to break the surface a little and allow it to bend . You’ve got to be careful, because cut too deeply and you’ll end up with a sliced edge that’s unattractive and also may delaminate ( come apart ).
Finished – with nice tightly wrapped edges that are staying in place .
wallcovering installer houston installation

Out Smarting a Tough Corner

July 27, 2021

In the top photo, I am hanging a new strip of wallpaper, moving from right to left, about to turn around that outside corner and move on to the left.

The strip of wallpaper is going to land about 3/8″ from that corner. This is not good, particularly with this specific paper. That 3/8″ does not provide enough surface for the wallpaper to grab ahold of, to be stable as the strip continues around the corner. You are also likely to get wrinkles as the paper wraps around onto the new wall.

It would be much better to have a wider strip of paper turning the corner on that first wall. I figured out a way to do that, while still matching the pattern perfectly in the corner to the right.

Because the pattern repeats itself once horizontally on the strip, this means there are two of the “circle” motifs, and I can use either one for my new strip. (I know, kinda hard to explain.) I chose to use the option that involved slicing the strip in half vertically, which left me with a narrower strip that fell far away from that corner to the left (and closer to the inside corner to the right). In the second photo, the location of this seam is marked by the blue tape.

Because that strip was narrow, the next strip was wider – wide enough to cover the remaining part of the first wall to the left and then wrap around the outside corner, and then into the inside corner on the far left.

I will also note that this vinyl material was very thick and stiff and uncooperative. It helped a lot to use the heat gun to soften the vinyl so it would wrap more easily around the corner and hug it tightly.

This wallpaper is made by Katie Kime.

For the record, their Customer Service told me that, due to material shortages due to the pandemic, they can’t get their usual very nice non-woven substrate, so are temporarily printing on this heavy vinyl material.