Posts Tagged ‘wrap around the corner’

Jimmying the Kill Point

November 3, 2019


This is a shot of the last corner in a room, a spot we call the kill point. Almost always, this last corner results in a pattern mis-match.

In this case, the heavy vertical tree trunk was going to land just 5″ away from the identical tree trunk, which was originally close to the corner in the photo.

Two heavy tree trunks, both curving in the same direction, covered with the same leaves and flowers, would be very obvious to the eye. Not a big deal, because this is in a far corner up over a door. But, still, I thought I could remove the repetitiveness and make it look better.

Without going into a lot of detail, I took some scrap paper that did not match the pattern, and tucked its right side under the vertical tree trunk.

I used its left side to paste on top of / cover up the tree trunk that was originally in the corner.

Instead of cutting exactly in the corner, I allowed some leaves and flowers to wrap around the corner, trimming around them with a scissors so they were not cut off abruptly, but wrapped naturally around the corner in a continuation of the motifs.

Why Doesn’t the Pattern Match in the Corner?

December 27, 2015

Digital Image

Digital Image


When you wrap wallpaper around an inside corner, you never wrap the whole strip, but rather cut the strip vertically so that just a tiny bit wraps around the corner, and then you overlap the next piece on top of that. This allows for undulations in the corner, keeps the paper tight in the corner, prevents puffed areas, permits you to re-plumb the new strip – but it also means that a tiny bit of the pattern will be lost, due to the overlapped area.

In most cases, that overlap is minimal, and you don’t notice the lost pattern. But in this case, in the remodeled attic of an 80 year old home, the ceilings were not level, the walls were not plumb, and the corners were not even straight (meaning, some of them were bowed).

The corner in the photograph was off by a good 1/2″ from the ceiling to the countertop. The 12″ wide strip I cut wrapped the corner a wee bit at the top of the wall, but by the time it reached down to the vanity top, almost half an inch was wrapping around the corner. This means that that 1/2″ would be covered up by the subsequent strip – and that means that the pattern would be distorted, as you see in the photograph.

I could have measured carefully and trimmed carefully, and cut the strip to fit the corner with minimal overlap. But that would have meant that the new strip of wallpaper would not be hanging true-to-plumb – and that would have meant that the motif at the ceiling and floor lines and along door jambs would be going crooked.

So, you have to pick you poison.

I decided that the pattern mis-match on this busy pattern was minor enough that it would not assault the eye, and I preferred it to the option of having the pattern go crooked at the ceiling and doors.

This wallpaper pattern is called “Emily,” and is by Hygge & Weste, an on-line company. http://www.hyggeandwest.com/