Posts Tagged ‘young boy’

Serena & Lily “Feather” In Boy’s Bedroom

March 20, 2020


I like Serena & Lily papers, and their “Feather” is one of their most popular. Here it is in navy in the bedroom of a young boy in the Woodland Heights neighborhood of Houston.

The room presented some challenges, but the pattern was accommodating. It took a whole lot of time, but when I finished, it looked great.

The 4-square house was built about 1920. In the ensuing years, the house has shifted. Which is a nice way of saying that the floors and ceilings are not level, and the walls are not plumb.

I started to center the pattern on a plumb line between the two windows. But a plumb line is plumb, and the window moldings were not, so the wallpaper pattern would have started going crooked along the windows and ceilings. So instead of lining my first strip up against a plumb line, I carefully placed it to straddle an area equidistant between the two windows.

This took a lot of measuring, a lot of repositioning, and a lot of trips up and down the ladder. And, yes, I even had the strip in place, trimmed, and done – and then realized that it was a tad off. So I pulled it off the wall and moved it over by a scant 3/16 of an inch. The effort paid off, because, as you can see in the first photo, the design is perfectly centered between the two windows, from ceiling to floor.

The next full strip hung to the right of the window on the right (no photo). This wall was way off-plumb, and was shaped more like a trapezoid than a rectangle. My job was to keep the pattern looking straight along the window frame on its left, as well as straight along the door frame to its right.

The only way I could do this was to slice the strip apart vertically, cutting along the vertical “stripes” in the design. Then I aligned the pattern to the left and right moldings. In between, I overlapped the “stripes,” distributing the discrepancy in widths between the sections. In this way, I accommodated for more than an inch of difference in width between the top and bottom of the wall. This did create a slight vertical ridge under the stripes, but it was disguised by the stripes themselves. And a little difference in thickness of the wallpaper looks a whole lot better than a crooked pattern.

To the right of that was a wide closet door. I hung the three strips over the door, and the pattern was placed perfectly. Yet when I stepped back and looked at it, the design looked horribly crooked.

I finally figured out that the ceiling and door moldings were not perfectly perpendicular to each other. In fact, there was a full 3/4″ difference in height between the left and right side of the area. This trapezoid shape was causing the strips to look crooked, even if they were not.

Again, my solution was to cut the paper apart vertically along the “stripes,” and overlap as needed, to make my strips look plumb.

I employed this trick as needed in other areas of the room.

The design itself was very helpful. The vertical “stripes” were not straight, so nothing had to be exactly-dactly straight or plumb. And the “V”s at the top of the wall were also irregular, as were the positioning of the diagonal lines, so I had flexibility in how high or low to place my pattern.

Throwing another wrench into the works was the fact that we had two different runs to work with (do a Search here to learn about that), plus one double roll bolt that was defective and could not be used, which meant I had to figure out how to make 10 rolls cover 12 rolls’ worth of wall space.

Another obstacle was placing the wallpaper against the stained shiplap wall – without getting paste onto the rough, un-cleanable wood. And let’s not forget to mention the “industrial” metal pipe that hung 1/2″ from the wall I was papering.

I used two tricks for this. One was using my Boggess blue cut tape to protect the wooden wall. The other again involved using the trim-along-the-stripe-and-overlap-new-strip-as-needed technique. Too intricate to explain, especially without photos. But it was a good trick and the perfect solution to ending the paper at the wooden wall.

Sounds complicated. It WAS! It took me 10 hours (3+ hours per wall) to get these 10 single rolls up.

When all was said and done, though, the room looked fantastic. All ready for the young boy to move in!

Other parts of the room have a heavy “industrial modern” look – exposed pipe, weathered metal light fixtures, unpainted original shiplap wood. The interior designer is Stacie Cokinos of Cokinos Design.

Fairytale Wonderland for Young Boy’s West U Bedroom

May 9, 2019


This young family in the West University Place neighborhood of Houston started out with another installation company that was not a good fit. They also started out with a wallpaper selection from a company that I find to be of poor quality (Hygge & West). I was honored that they let me take on the wallpaper install. AND that they listened to my suggestion to explore other manufactuers … the paper they chose is superior in quality, and is a far more charming and fitting design for their young son.

The walls originally had a light texture that I skim-floated over, then sanded smooth, and then primed with Gardz.

The new wallpaper is very similar in color to their original choice of palm leaves, so they could keep the trim and wainscot paint that had already been applied.

Whereas paper from the original manufacturer is known for curling and disappointing “pouches” at the seams, their final selection from Boras Tapeter (a Scandinavian company) is some of the most cooperative and best performing paper I have every worked with.

The seams are invisible, the material doesn’t expand (no pattern distortion or screwed up measurements) and it doesn’t shrink (no gaps at the seams). There is no booking time, so each strip can be pasted and then hung immediately. It can also be hung via the paste-the-wall method. It hugs the wall tightly and turns corners nicely. It doesn’t crease easily, as many thicker non-wovens do. When it’s time to redecorate, this non-woven material is designed to strip off the wall easily and with minimal damage to the wall. And the surface is more washable than most, making it well suited to a young child’s room.

And best of all, the “Wonderland” design, with frolicking animals and whimsical foliage, is much better suited to a child’s room than the original palm leaf option.

This wallpaper pattern is by Boras Tapeter, and was bought from my favorite source for good quality, product knowledge, expert service, and competitive price – Dorota Hartwig at Southwestern Paint on Bissonnet near Kirby. (713) 520-6262 or dorotasouthwestern@hotmail.com. She is great at helping you find just the perfect paper! Discuss your project and make an appointment before heading over to see her.